40
J-445/J-435 Export
A.
To change the default cycle:
When you enter the menu, “Start” and “12” will be
highlighted.
1. Tap or to change the hour in 1-hour
increments. To switch from “AM” to “PM” you
must round a 12-Hour period.
2. Tap to accept the change.
3. Tap
End
to program the end time for the
cycle.
4. Tap the hour block to change the end time.
5. Tap or to change the hour in 1-hour increments. To switch from
“AM” to “PM” you must round a 12-Hour period.
6. Tap to confirm and save your changes.
7. Tap
, a couple of times, to return to the Heat & Filter Menu and
the Settings Menu.
Summer Logic:
In warm weather, the water temperature in the spa
may exceed the set temperature. This condition may occur due to
heat transference from the filter/circulation pump and jets pumps.
If the water temperature is higher than 35°C (95°F) and 1°C (2°F)
above the set temperature, a “Summer Logic” condition occurs that
deactivates the filter/circulation pump and CLEAR
RAY
®. This safety
feature cannot be altered! The filter/circulation pump and CLEAR
RAY
will remain off until the water temperature cools to the set temperature
(except between 9am-11am when the filter/circulation pump runs
for it’s mandatory 2 hour cycle.) To help prevent a “Summer Logic”
condition, it may be necessary to reduce filter/circulation pump cycles
run times in warm weather.
Figure 12.3c
Start
End
pm
12
12pm
EcoMode
8pm
Primary Filter
Summary of Contents for J-435
Page 1: ...J 435 J 445 EXPORT OWNER S MANUAL 6530 274EE Rev C...
Page 6: ......
Page 79: ......
Page 80: ......