68
J-445/J-435 Export
POOR JET ACTION
1. Make certain the jets pump is turned on.
2. Check position of massage selectors.
3. Open air control for selected jet system.
4. Check for adequate water level.
5. Check for dirty filter (page 49).
WATER IS TOO HOT
1. Reduce thermostat setting.
2. Switch hot tub to “Econo” mode to turn
heater on only during pre-programmed
3. Make sure the pumps are turned off and
not constantly running.
NO HEAT
1. Check thermostat setting.
2. Keep the cover in place while heating.
3. If heater indicator is displayed, but no
temperature increase is experienced after
a reasonable period of time, contact your
dealer or authorized service center.
FILTER/CIRCULATION
PUMP OFF
1. Verify filter/circulation pump is
2. Make sure there are no errors preventing
the pump from turning on.
3. Hot tub water is warmer than 34°C
(95°F) and 1°C (2°F) warmer than the set
temperature. The “Summer Logic” safety
feature has activated. See note on page
Jacuzzi builds the best spas in the industry. Nonetheless, we are always
striving to improve the quality and features of our products. Your input
as a Jacuzzi spa owner is a cherished part of this process. If you have
any comments or suggestions, or if you wish to be informed on any new
products for your spa, please write to us.
CONGRATULATIONS
on your good taste and welcome to the happiest
and most relaxed family in the world!
Summary of Contents for J-435
Page 1: ...J 435 J 445 EXPORT OWNER S MANUAL 6530 274EE Rev C...
Page 6: ......
Page 79: ......
Page 80: ......