67
J-400
5. Open all the air controls and leave them open until you resume use
6. When the water level ceases to drop, use whatever means available
to remove any remaining water from the footwell, such as a wet/dry
vacuum.
7. Remove the equipment-side cabinet panel(s) and locate the drain
plugs in the front of each pump (Figure B, page 14). Remove
these plugs to allow the water to drain out of the pumps and heater.
Note:
Approximately one to two gallons will be released during this
procedure. Use a wet/dry vacuum or other means to keep this from
flooding the equipment compartment. Replace the drain plugs.
8. Loosen hose clamp at bottom of heater (Figure B, page 14) and
pull hose off of heater fitting (twist the hose back and forth while
pulling downward). Tip hose down and allow it to drain and then
reinstall hose and clamp.
9. Loosen the hose clamp on the circulation pump (if equipped) intake
behind the control box (Figure B, page 14) and pull the hose off
(twist hose back and forth while pulling outward). Tip hose down and
allow it to drain and then reinstall hose and clamp.
10. Loosen hose clamp at bottom of CLEAR
RAY
system and pull hose
off of CLEAR
RAY
fitting (twist the hose back and forth while pulling
downward). Tip hose down and allow to drain. Then reinstall hose
and clamp. Remove the cover of the CLEAR
RAY
system to access
the UV bulb and quartz tube. Remove and store the UV bulb in a
safe location. Remove and dry off the quartz tube then reinstall it.
Depending on the length of time, consider replacing the UV bulb
when you resume use of your hot tub.
11. Re-install cabinet panels and cover spa so that no casual moisture
can enter into it.
Consult your Jacuzzi dealer if you have any questions regarding winter
use or winterizing.
13.9 Restarting Your Spa in Cold Weather
If you want to start up your spa after it has sat empty for a time in
freezing temperatures, be aware that the water remaining in certain
Sections of the piping may still be frozen. This situation will block water
flow preventing the spa from operating properly and possibly damaging
the equipment. We recommend you consult your dealer for guidance
before attempting to restart your spa under these conditions.
