IMPORTANT SAFETY INFORMATION
READ ALL INSTRUCTIONS BEFORE BEGINNING ASSEMBLY AND INSTALLATION.
SUMMARY OF PRECAUTIONS
• Suction cover must be in place at all times to minimize the potential for hair and body entrapment.
• Keep body and hair a minimum of 6" away from suction fitting at all times when the whirlpool system is operating. Hair longer
than shoulder length should be secured close to the head.
• Other than those built into this unit, never operate electrical appliances (hairdryer, telephone, television, radio etc.) inside or
within 5 feet of the bath.
• Never leave small children unattended in the bath.
• Do not use oil-based bath additives in your whirlpool bath.
• When cleaning your bath, do not use abrasive substances which will damage the bath's surface.
• A maximum water temperature of 104
°
F is recommended. Bathing at temperatures above 104
°
F for prolonged periods can
be injurious to health.
• To prevent discoloration of the acrylic finish, do not fill the bath with water in excess of 140
°
F.
• The whirlpool system should be purged at least twice a month. For your convenience, we have developed a plumbing system
cleaner (Systems Clean™) specifically for whirlpool baths. For availability call 1-800-288-4002.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: When using this unit, basic precautions should always be followed, including the following:
Read and follow all instructions.
DANGER: to reduce the risk of injury, do not permit children to use this unit unless they are closely supervised at all times.
Use this unit only for its intended purpose as described in this manual. Do not use attachments not recommended by the
manufacturer.
Never drop or insert any object into any opening.
Do not operate this unit without the suction cover in place.
This unit must be connected only to supply circuits that are protected by a ground fault circuit interrupter (GFCI). Such a GFCI should
be provided by the installer and should be tested on a routine basis. To test the GFCI, push the test button. The GFCI should
interrupt power. Push the reset button. Power should be restored. If the GFCI fails to operate in this manner, there is a ground
current flowing, indicating a possibility of an electric shock. Do not use the unit. Disconnect the unit and have the problem corrected
by a qualified electrician before using.
A pressure wire connector is provided on the exterior of the motor to permit connection of an No. 8 AWG (8.4 mm) solid copper
bonding conductor between this unit and all other electric equipment and exposed metal in the vicinity, as needed to comply with
local requirements.
WARNING: When using electrical products, basic precautions should always be followed including the following:
DANGER: RISK OF ELECTRIC SHOCK. Connect only to a circuit protected by a ground fault circuit interrupter.
Grounding is required. This unit should be installed and grounded by a qualified electrician.
Install to permit access for servicing.
Note: This is a professional grade product. A good knowledge of construction techniques, plumbing and
electrical installation according to codes are required for proper installation and user satisfaction. We
recommend that a licensed contractor perform the installation of all Jacuzzi Whirlpool Bath products. Our
warranty does not cover improper installation related problems.
Options
Trim Kits (P412827 Chrome, P412898 Brushed Chrome, P412828 Gold, P412829 Bright Brass, P413827
Chrome, P413898 Brushed Chrome, P413828 Gold, P413829 Bright Brass)
Drain Kits (8730827 Chrome, 8730898 Brushed Chrome, 8730828 Gold, 8730829 Bright Brass)
Summary of Contents for J-ALLURE J-ALLURELuxury Bathing and Entertainment...
Page 30: ......
