background image

IMPORTANT SAFETY INFORMATION

READ ALL INSTALLATION INSTRUCTIONS

Jacuzzi Whirlpool Bath does not recommend prolonged periods of use of the steamer.  Prolonged use of the steam
system can raise the internal human body temperature excessively and impair the body's ability to regulate its internal
temperature (resulting in  hyperthermia).  Consult your physician about your safety and comfort before using the steam
system; limit your use of steam to 10-15 minutes until you are certain of your body's reaction.  A cooling shower spray
can be used simultaneously with the steam to assist in regulating your body temperature.

Alcohol, certain drugs or medications such as tranquilizers affect a person's ability to withstand high temperatures and
may produce dangerous side effects.  Do not use alcohol or drugs when using the J-Dream.

The elderly, the infirm, and children should not use the J-Dream unattended.  Pregnant women and people with heart
conditions should consult their physicians before using the steamer.

The wet surface of the J-Dream can be slippery.  Use care when entering and exiting.

When using the J-Dream, basic safety precautions should always be followed:

This unit is connected to a Ground Fault Circuit Interrupter (GFCI); This is also known as an Earth Leakage Circuit
Breaker (ELCB). Check at least once a month to be sure this is operational.  With the unit operating, push in the test
button.  The unit should stop operating and the trip indicator should appear.  Restore the power; push to OFF, then
turn ON.  The unit should now operate normally.  If the interrupter fails to operate in this manner, there is a fault in the
electrical system or the GFCI and you may not be protected from an electrical shock.  Turn off the power and have
a qualified electrician check the circuit before using it again.

Do not use electrically connected devices such as television, radio, or stereo speakers, lights, hair dryers, or
telephones within 1.5 m (5 feet) of the J-Dream while in use.

Read manufacturer's safety information with all optional equipment.

MODEL

J-Dream 90

ELECTRICAL
REQUIREMENTS

240 VAC 60 Hz
15AMP
(Must be GFCI
protected)

SPECIFICATIONS

Owner's Record

Save These Instructions for Future Use.

 Date Purchased

 Purchased From

 Installed By

 Serial Number

SHIPPING
WEIGHT

(182kg)
400 lb

WATER
HEATER

(151 liters)
40-U.S. gal

REQUIRED
WATER SUPPLY

3.0 gpm @
20 -65 psi
11 liters /min.
@ 1.5-5.0 bars

FLOOR
LOADING

Total Weight:
225 kg
(495 lb)
234 kg/m

2

(48 lbs./sq.ft.)

MOTOR/PUMP

0.50 hp
240 VAC
3450RPM
Single Phase
60 Hz

DIMENSIONS

50-3/8" (1000 mm) L
29-1/2" (  750 mm) W
84-1/4" (2159 mm) H

PRODUCT SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.

2

Summary of Contents for J-DREAM 90















Reviews: