Attention New Spa Owner!
Congratulations on the purchase of your new Jacuzzi® spa! The following is a
list of automated functions performed by your spa. These functions are listed
below in an attempt to alleviate any operational concerns you may have during
the first 24 hours of ownership! Also listed below are important maintenance
recommendations you should observe on a regular basis to protect your new
investment.
Automated Operations
Approximately two minutes after power is applied to the spa, the first filtration/
heating cycle turns on pump 1. An automatic five minute “blow-out” function also
activates pump 2 for a period of five minutes to flush all lines. Then, after five
minutes, pump 2 turns off and pump 1 continues to operate for the duration of the
cycle.
Note:
This function only occurs during the first filtration/heating cycle each day.
Maintain Healthy Spa Water
Always maintain your spa’s water chemistry within the following parameters:
With
CLEAR
RAY®
Without
CLEAR
RAY®
pH
7.4-7.6
7.4-7.6
Free Chlorine
no less than 1.0 ppm 3.0-4.0 ppm
Free Bromine
no less than 2.0 ppm 2.0-4.0 ppm
Total Alkalinity
100-120 ppm
100-120 ppm
Calcium Hardness
150-250 ppm
150-250 ppm
IMPORTANT:
CLEAR
RAY
® Water Purification System is factory installed. If
the CLEAR
RAY
® system is altered or is not operating efficiently then follow
the “without CLEAR
RAY
®” water chemistry parameters as defined by the
Association of Pool and Spa Professionals. CLEAR
RAY
® requires an annual
bulb replacement to properly sanitize your water.
!
TO DECREASE RISK OF INFECTION OR DISEASE!
Always maintain
your spas filter as outlined below to ensure healthy spa water. Refer page
43 “Water Quality Maintenance” for additional information.
Required Filter Maintenance
Your new spa is equipped with an advanced water filtration system that provides
unsurpassed water quality! To ensure maximum water quality at all times, you
should clean both filter cartridges every month, or earlier as necessary. See page
35 for detailed filter cartridge cleaning/replacement instructions.
Required Water Replacement
!
TO DECREASE RISK OF INFECTION OR DISEASE!
You should replace
the spa’s water every 3 months. The frequency depends on a number of variables
including frequency of use, number of users, and attention paid to water quality
maintenance. You will know it is time for a change when you cannot control
sudsing and/or you can no longer get the normal feel or sparkle to the water,
even though the key water balance measurements are all within the proper
parameters. See page 43 for additional information.
© Jacuzzi Hot Tubs. All Rights Reserved
