16
LX Collection
IMPORTANT:
Always fill your spa through the filter bucket after
draining. Failure to do so may cause air to be trapped in either
pump, preventing the pump from circulating water. Remove the
hose and replace the filter cartridge. Note: DO NOT overtighten
filter cartridge, finger tight only!
3.
Turn On Power
Turn on power to spa at the home’s circuit breaker to start boot up
sequence (Sec. 10.0, page 27). The heater and filter pump will
automatically activate after several seconds. If the control panel LED
flashes water temperature and “COL” or “ICE” this is normal, refer to
page 48 for additional information.
Note:
“COL” and “ICE” will only appear when the spa is in Economy
mode.
4.
Activate Jets Pumps
Turn on jets pump(s) to ensure proper mixing when
adding start-up chemicals in step 5.
5.
Add Start-Up Chemicals
Add the spa water chemicals as recommended by your authorized
Jacuzzi dealer. Section 13.0 “Water Quality Maintenance” (page
WARNING:
RISK OF POISONING OR DEATH.
Never leave chemicals opened and accessible to anyone.
Use chemicals according to the vendors instructions. Always
store chemicals in a safe and/or locked location. Keep away
from and out of reach of children.
!
6.
Establish A Stable Sanitizer Reading
Establish a stable sanitizer reading of no less than 1.0 ppm free
chlorine or 2.0 ppm bromine. To ensure healthy water conditions,
always maintain a constant sanitizer reading within the levels
recommended on the inside cover of this manual. If sanitizer levels
cannot be stabilized, perform the decontamination procedure steps
9-15 on the following page.
Note:
The “decontamination procedure” steps 9-16 should also be used
after the spa has been “Winterized” (Section 12.9, page 41) or has
been sitting without power for an extended period.
7.
Set Spa To Heat
To warm spa water to a comfortable temperature,
follow these steps:
• The LED display on the control panel displays the actual temperature
of the spa water. Press either the
COOLER
( ) or
WARMER
( ) button once to display the “set” temperature for 5 seconds. If
you want the water to heat to a different temperature, simply press
2
1
