Spa maintenance
Proper and regular maintenance of your spa will help it retain
its beauty and performance.
Information regarding spa cleaning and maintenance
and the products to be used can be found in the cata-
logue-guide provided with the product.
Cleaning the filters
Your Jacuzzi
®
Premium spa is equipped with a skimmer and two
high-performance filter cartridges located inside the skimmer.
Fine debris is filtered by the circulation pump drawing water
through the skimmer bag and circulation pump cartridge.
Larger impurities are filtered by the 2-speed pump drawing wa-
ter through the skimmer bag and main pump cartridge during
normal operation and at each skimming/heating cycle.
To ensure optimum performance, clean both cartridges once a
month.
Dispenser for water sanitation
At authorized Jacuzzi dealers, you can purchase a dispenser
where you can place products for water sanitation).
Dispenser for water sanitation
At authorized Jacuzzi dealers, you can purchase a dispenser
where you can place products for water sanitation).
This dispenser must be placed in the filtering cartridge (rec-
ognizable by the grille cover on the compartment) connected
to the circulation pump.
The dispenser must always be removed (while wearing latex
gloves) along with its cover during cleaning of the filter, and
is to be reinstalled when this operation is complete.
ALWAYS TU R N POWE R TO S PA B E FOR E CLEAN I NG
THE FILTER CARTRIDGES!
Refer to the filter cleaning/replacement procedure below:
A. Turn off power to spa.
B.
Tilt cover forward to access filter cartridges.
(The skim shield is connected by spring clips, use caution so the
lid does not snap back.)
C.
Remove skimmer bag from clips, clean out, then reinstall in
the filter cover.
Replace the filter skimmer about every three months, depend-
ing on spa use.
D
Rotate each filter cartridge handle counterclockwise to un-
thread from mating wall fitting.
E.
Lift unthreaded filter cartridge from skimmer well.
F.
If used, remove the chemical feeder as instructed prior to
rinsing the filter cartridges. Rinse debris from filter pleats on each
cartridge using a garden hose and high pressure nozzle. Start
at the top and work downward towards handle. Repeat until all
pleats are clean.
G.
Submerge both filter cartridges in spa. Tilt threaded end up-
ward to remove trapped air bubbles, then keep cartridges sub-
merged to prevent air entrapment during installation (step H).
H.
Place each cartridge back into skimmer well, then rotated
each cartridge handle clockwise to thread back into wall fitting.
DO NOT OVERTIGHTEN!
I.
Install clean skimmer bag and filter skimmer back onto the fil-
ter cover clips as shown (you can flip the filter skimmer and use
the back side to extend usage). Replace the filter skimmer about
every three months, depending on spa use.
J.
Tilt filter cover back against the spa shell.Turn power to spa
back on.
B
C
D
(Spa Shell)
E
F
G
Trapped
Air
Bubbles
Cartridge 1
Cartridge 2
H
I
J
31
Summary of Contents for J-LXK
Page 2: ... Italiano 03 English 23 Français 42 Index ...
Page 22: ......
Page 62: ......
Page 63: ......
