Note:
If the spa power is interrupted, the duration count- timer is
not affected. The number of days remaining is stored in the mem-
ory and will continue to count- once power is regained.
If the duration count- timer is not at “0” and you need to reset it:
A.
Press and hold the Jets pump 1 and Cooler buttons at the
same time for 3 seconds.
B.
Press the Warmer button to scroll to “U”.
C.
Press the Jets pump 1 button to switch from “U” to “O3”.
C.
Press and hold the Jets pump 1 and Cooler buttons at the
same time for 3 seconds.
E.
Press the Warmer button to scroll to “O3”.
D.
Press the Jets pump 1 button to switch from “O3” to “U”. The
timer has been reset to 365 days.
Spa maintenance
Proper and regular maintenance of your spa will help it retain its
beauty and performance.
Information regarding spa cleaning and maintenance and
the products to be used can be found in the catalogue-guide
provided with the product.
Cleaning the filters
Your Jacuzzi
®
Premium spa is equipped with a skimmer and two
high-performance filter cartridges located inside the skimmer.
Fine debris is filtered by the circulation pump drawing water
through the skimmer bag and circulation pump cartridge.
The largest impurities are filtered by the two-speed pump that
forces the water into the skimmer net and the other filter car-
tridge during normal hydromassage operation (high speed) and
every filtering/heating cycle (low speed).
Clean the filter cartridges once a month, increasing the frequency
during periods of intense usage.
ALWAYS TURN POWER TO SPA BEFORE CLEANING THE FILTER
CARTRIDGES!
Refer to the filter cleaning/replacement procedure below:
A. Turn off power to spa.
B.
Tilt cover forward to access filter cartridges.
(The skim shield is connected by spring clips, use caution so the
lid does not snap back.)
C.
Remove the skimmer netand cap from the catches and clean
them; then refit the net in the cap.
Replace the cap approximately every three months, depending
on how much the hot tub is used.
D
Rotate each filter cartridge handle counterclockwise to un-
thread from mating wall fitting.
E.
Lift unthreaded filter cartridge from skimmer well.
F.
Rinse the filter folds on each cartridge. Start from the top and
work down in the direction of the handle.
Repeat until all the folds have been cleaned.
Start at the top and work -ward towards handle. Repeat until all
pleats are clean.
G.
Submerge both filter cartridges in spa. Tilt threaded end up-
ward to remove trapped air bubbles, then keep cartridges sub-
merged to prevent air entrapment during installation (step H).
B
C
D
(Spa Shell)
E
F
G
Trapped
Air
Bubbles
Cartridge 1
Cartridge 2
H
I
J
41
Summary of Contents for J - LXL
Page 2: ...2...
Page 3: ...Italiano Avvertenze 4 English Warnings 29 Fran ais Recommandations 53 Index...
Page 78: ......
Page 79: ......
