J-Sha II Owner's Manual
80-130
130-220
110-150
TIME
SPEED
INTENSITY
+
+
_
+
_
0
25
_
TONIC
RELAX
+
+
+
_
_
_
MIX
ON
OFF
ON/OFF BUTTON
& LED
BODY JETS BUTTON
& LED
TIME BUTTON
& LED SCALE
INTENSITY BUTTON
& LED SCALE
AIR INCREASE
& DECREASE
BUTTONS & LED
SQUARE WAVE BUTTON & LED
MAXIMUM PEAK BUTTONS & LED
ROLLING WAVE BUTTON & LED
FREQUECY BUTTONS & LED
MINIMUM PEAK
BUTTON & LED
WHIRLPOOL
Press BODY JETS button:
The body jets led will come on while the TONIC indi-
cator, 110-150 LED and the SPEED scale will all turn
off. The value on the TIME and INTENSITY scales
will change to preprogrammed values. The duration
of this cycle is about 20 minutes. The intensity of the
jets are held constant and the air is off.
VARIATIONS FROM DEFAULT SETTINGS
TIME or INTENSITY:
Repeatedly press + or - buttons for each function.
Variations from the preprogrammed values are dis-
played by the relative LED scales.
AIR:
The default for body jets is air off. Press the upper
AIR button to turn on the air flow. The LED turns on.
Press the upper button to increase the air flow from
the body jets. Press the lower air flow to decreases
air flow. When the LED goes off, the air is off.
For pulsating air flow, press and hold the upper or
lower air button twice. The LED flashes to indicate
this mode. To turn off press either button once again.
ROLLING function:
Press the ROLLING button. The LED comes on. In
this cycle the intensity of the jets is gently modulated
with repeated pulses. The cycle starts with a mini-
mum intensity to a maximum intensity with an imme-
diate drop off toward the minimum. Press again to
return to continuous flow operation.
SQUARE function:
Press the SQUARE button. The LED comes on. In
this cycle the intensity of the jets is energetically modu-
lated with short repeated pulses. The maximum peak
will last for an interval then drop off to the minimum.
Press again to return to continuous flow operation.
FREQUENCY:
The speed of the whirlpool jet action can be increased
or decreased by the use of these buttons. Press + or
- buttons to increase or decrease the frequency of
either the rolling or square pulses. The LED comes
on.
MAXIMUM & MINIMUM PEAKS:
The whirlpool jet action can be made more or less
gentle, or more or less forceful by use of these but-
tons. Press + or - buttons to increase or decrease
the maximum or minimum peaks of either the rolling
or square pulses. The LEDs comes on.
WHIRLPOOL OPERATION
10
