1
Important
The bathtub must be installed per installation instructions D884000 for the Merano™ or E160000 for the Siena™.
Follow the instructions to ensure that proper framing has been provided to support the J-Shower Tower. Finishing
materials must be waterproof and sealed so that spray and condensation do not cause moisture damage.
NOTE: The J-Shower Tower has been partially pre-assembled for your convenience during installation.
The installer must still follow the instructions to ensure proper installation of the tower and components
(see page 13). We recommend that two persons perform this installation.
Contents
Exploded View of J-Shower Tower ________________________________________________________
2
Shower Tower Hardware Identification Chart __________________________________________________
4
Tower Assembly _______________________________________________________________________
7
Water Lines to Mixer/Diverter Valve _________________________________________________________
10
Attaching Diverter Valve to Shower Wall _____________________________________________________
10
Tower Installation ______________________________________________________________________
12
Tower Disassembly ______________________________________________________________________
13
Placing Tower __________________________________________________________________________
14
Fixed Panel Assembly ____________________________________________________________________
15
Mounting Top Ring and Wall Bracket to Tower _________________________________________________
17
Fixed Glass Frame Attachment _____________________________________________________________
19
Sealing and Trimming ____________________________________________________________________
20
Attaching Face Plate _____________________________________________________________________
21
Handle Installation _______________________________________________________________________
21
Handle Operation _______________________________________________________________________
22
Tools Required
1.
Drill.
2.
Drill bits: 3/32", 1/8", 3/16" and 5/16".
3.
Flat blade screw driver, No. 1.
4.
Phillips type blade screw driver, No. 2.
5.
5/16" or 8 mm deep socket or nut driver.
6.
Caulking gun.
7.
Sealant (100% silicone).
8.
Adjustable wrenches (small and medium).
9.
Allen wrenches: 1.5 mm, 2.5 mm, 3 mm and 5/64".
10. Step ladder.
Summary of Contents for J-SHOWER TOWERTM
