NEO-ANGLE
SINGLE THRESHOLD
PRODUCT CHART
J-STONE
™
SHOWER BASES
WHIRLPOOL
BATH
R
B
A
C
D
A
A
D
D
B
C
B
D
21-3/16"
17-3/16"
17-3/16"
18-3/16"
12-3/16"
12-3/16"
C
21-3/16"
24-3/16"
30-3/16"
18-3/16"
25"
25-1/8"
B
42-3/16"
34-3/16"
34-3/16"
36-1/8"
18-3/16"
20-3/16"
A
42-3/8"
48-3/8"
60-3/8"
36-5/16"
36-1/8"
38-1/8"
MODEL
SS 4242
SS 3448
SS 3460
SS 3636
SS 36NEO
SS 38NEO
ROUGH-IN DIMENSION
PRODUCT
NO.
PO45
PO41
PO46
PO42
PO43
PO44
NOMINAL
SIZE
42" X 42"
34" X 48"
34" X 60"
36" X 36"
36" X 36"
38" X 38"
INSTALLATION
With the drain fitting passing over the center of the
drainpipe, lower the shower base carefully into place,
push down firmly until the base is in place.
Provide an opening in the subfloor no less than 5" x 5"
square. See product chart for hole location. The
opening is to accommodate a 2" waste pipe.
If the subfloor is level, no other preparation is neces-
sary. You can proceed to install the shower base. If the
subfloor is not level, you MUST level the entire surface
prior to installing the base. (Use a floor leveling com-
pound.) Do not level shower base with mortar. Both
sides of a joint or splice of subfloor should be level to
each other. Level and support waste pipe cutout area
greater than 5" x 5".
