8
5.2 Primary Filtration Program
•
Follow the steps below to access the program. Included within the Primary Filtration Menu, is the
Change Filter feature.
•
Two methods for setting the filter cycle start time are possible:
1. Turn power on to the hot tub two minutes prior to the desired filter cycle start time, or
2. Press and hold the WARMER, COOLER and JETS Pump 1 buttons at the same time, to
reset the control panel and start the power-up sequence.
A.
Cleanup “Blow-Out” Cycle
This cycle is activated once every 24 hours in either Standard or Economy mode. The Cleanup
Cycle shall start before the first filtrations cycle. Pump 1 will activate for 1 minute and then shut off.
Then Pump 2 will activate for 1 minute and then shut off.
B.
For Models J335 to J385
Two minutes after power is applied to the spa, an automatic primary filtration cycles begins. The
circulation pump is activated and set to run for 8 hours a day (factory default). The circulation pump
draws water through the skimmer bag and one of two filter cartridges to effectively remove small
debris in your spa. During the primary filtration cycle, the circulation pump and CLEAR
RAY
are acti-
vated. The factory default setting is PF2. This setting is programmable.
Note:
The circulation pump also supplies heated water to the spa when the heater turns on.
Any
time the circulation pump runs outside of a programmed cycle (except for PF0 and PF6), that
run time will reduce the length of the next cycle.
C.
For Models J315 and J325
Your new spa includes a
24-hour primary filtration system
, which filters the water continuously
(factory default). The circulation pump draws water through the skimmer bag and one of the two filter
cartridges to effectively remove small debris in your spa. The factory default setting is PF6. This set-
Menu button Action
Result
Press once
To access the Primary Filtration Menu. The LED will display “PF.”
or
Press once
Activates the system for changes. Last programmed cycle blinks once on
the display.
or
Press
continually
Scrolls through the menus as follows:
,
,
,
,
,
,
,
or
Press once
The new programmed cycle will blink twice on the display to confirm your
selection.
No filtration
4 hours of filtration per day
8 hours of filtration per day (
default setting for J-335 to J-385
)
12 hours of filtration per day
16 hours of filtration per day
20 hours of filtration per day
24 hours of filtration per day (
default setting for J-315 and J-325
)
2 hours of filtration – 4 times per day
3 hours of filtration – 4 times per day
Summary of Contents for LCD Series
Page 40: ...36 APPENDIX ...
