45
The nozzles on the backrest cannot be
disassembled
Maintenance
T
ub maintenance is rapid and simple: follow the advice provided here to easily withhold
performance and reliability with time.
ATTENTION! Before carrying out any maintenance operation, disconnect the
appliance from the power supply line.
Q
It is
simply sufficient to dry the various components; should you need to carry out a
more thorough cleaning procedure, eliminate any stains using a cloth dampened with
soapy water or neutral detergent; rinse with fresh water and dry.
Do not use abrasive towels, powdered detergents, acetone or other solvents.
When cleaning or rinsing the tub, water may enter the bottom part of the hydraulic circuit
via the nozzles located along the backrest; to eliminate this water, switch on the main switch
in order to activate the drainage valve (the message "Sc" will appear on the remote control
display); when the message disappears, turn off the switch.
Q
The tub may be periodically buffed using polish: contact a Jacuzzi® Support Centre,
even in the case of scratches or surface damage.
Q
Avoid prolonged exposure to UV rays.
Q
Proceed as indicated for the tub; subsequently to use, rinse any water traces under the
rear panel.
Do not use abrasive towels, powdered detergents, acetone or other solvents.
Q
Disassemble the various components as displayed; remove any residues using a soft
brush, water and a neutral soap.
Reassemble the components in reverse order.
1
2
tub,
brassware,
remote control
note on cleaning
the tub
rear panel-headrest
hydromassage
nozzle
air outlet
nozzle
