34
Then remove the 6 door screws for the access door on the con-
trol box.
Connect wires to the terminal block. ALL WIRES MUST BE SE-
CURELY CONNECTED or equipment damage could result!
Install control access box door and reinstall the cabinet side pa-
nels.
Spa Fill Up Procedure
For best results, read each step in its entirety before
proceeding with this procedure.
I
Prepare The Spa For Filling
- Clear all debris from the spa. (Although the spa shell has been
polished at the factory, you may want to treat it with a specially
formulated spa cleaner.)
Consult your authorized Jacuzzi dealer for additional information
prior to filling spa.
- Remove both ProClarity™ and ProClear™ Plus skimmer, pol-
ishing filter lids and filters as illustrated in Section “Cleaning
the Filter Cartridges”.
I
Fill Spa
Place the end of your garden hose into empty skimming filter
bucket (filter bucket on your left) as you stand next to the spa.
Fill spa half way, then place the garden hose into the opposite
filter bucket (filter bucket on your right) while adding the remain-
ing fill water.
CAUTION: TO DECREASE BUILD UP ON COMPONENTS
AND MINIMIZE ACRYLIC DAMAGE.
Never fill with water from a water softener. If your water is
extremely “hard,” it is preferable to fill half-way with hard water
and the rest of the way with softened water. Water that is too
soft can be corrosive to metal components.
WARNING:
to decrease RISK OF infection or disease.
Fill hot tub with clean tap water from garden hose, to reduce risk
of contracting a waterborne illness (e.g. an infection, bacteria or
virus) and/or respiratory ailments. Fill until water covers all jets
but does not touch the bottom of the lowest headrest (DO NOT
OVERFILL!).
IMPORTANT:
Always fill your spa through both filter buckets
after draining. Failure to do so may cause air to be trapped in
either pump, preventing the pump from circulating water. Remove
the hose and replace both filter cartridges as illustrated in Sec-
tion “Cleaning the Filter Cartridges”.
I
Turn on Power
Turn on power to spa at the home’s circuit breaker. The heater
and filter/circulation pump will automatically activate. If the
screen displays either a “Cool Warning” or “Freeze Protection”
error, this is normal. Normally, at the initial fill, the water tends
to be cold. Refer to “Error/Display Messages” for additional infor-
mation.
I
Activate Jets Pumps
Turn on jet pumps when adding chemicals (see Section “Acti-
vating the Jets Pumps” to activate jets).
I
Addition of chemcial additives at first start-up
Please refer to the Jacuzzi system water treatment guide and relative
catalogue for details on water quality maintenance, the methods and
warnings governing the use of relative chemical products.
Blu
Brn
Blu
Brn
BREAKER 1
BREAKER 2
N
L
L
N
