23
First set the hour and confirm with the
"Filter"
key. Then set
the minutes, and press the
"Filter
" key again to memorize the
set values and exit programming.
When the function is on, the display will shown the respective
symbol.
“Instant Clear”
This special type of filtering is recommended in special situa-
tions, such as before or after a party with friends, or to facili-
tate dissolution of substances used for water disinfection.
To activate the function, press the key
“Instant Clear”
. The
display will show the message
boo
.
The function lasts 45 minutes
(this value cannot be
changed)
. It can be stopped sooner by again pressing the same
key. The filtering pump and the hydromassage pumps are acti-
vated according to a special cycle. Refer to the installation man-
ual for further clarification.
For details on filtering, refer to the product's installation
manual.
Water heating
The water in the tub is heated by the electric heater located
in the tub compartment. Temperature adjustment is managed
by specific parameters to be set from the control panel.
Press the key
“Up”
or
“Down”
. The display will
show the currently memorized temperature, and the respective
symbol will appear.
Press the key
“Up”
or
“Down”
again to change the
displayed value from a minimum of15 °C to a maximum of 40
°C (59÷104 °F).
To show the temperature of the water in the tub again, do not
touch any key for about 5 seconds.
"Energy savings" mode
This function lets you keep the water temperature 10 °C (50 °F)
below the set temperature for a given period. However, you may
not programme temperatures of less than 15 °C.
Press the key
“Econo”
.
The display shows the message
Edx
, where “x” indicates the duration in hours.
Use the keys
“Up”
or
“Down”
to insert the desired
duration,
from a minimum of 0 to a maximum of 24, which
means the function is always on.
Press the
“Econo”
key again to confirm the selected val-
ue. You will then go to the start time (
Es
).
First set the hour and confirm with the
"Econo"
key. Then set
the minutes, and press the
"Econo
" key again to memorize the
set values and exit programming.
When the function is on, the display will shown the respective
symbol.
NOTES
- The minimum temperature that characterizes energy savings
mode may never be less than 15 °C (59 °F) (minimum main-
tenance temperature).
- If there is a power outage, the set data are stored in memory.
However, when the power comes back on, the function does not
resume. Rather, it is turned on at the set start time.
Filter
Instant Clear
Blower
Econo
Pump 1
Pump 2
Up
Down
13.30
AM
Filter
Instant Clear
Blower
Econo
Pump 1
Pump 2
Up
Down
Filter
Instant Clear
Blower
Econo
Pump 1
Pump 2
Up
Down
Summary of Contents for Profile
