Operating Manual
English
Page 12
www.jacuzzi.com
Clean the suction cover/strainer of hair and debris when necessary (Figure 19).
1. Remove the center screw and detach the suction cover.
2. Clean the cover by back flushing debris from the holes.
3. Replace the suction cover immediately after cleaning.
WARNING!
When reinstalling, orient the cover/strainer with the small
notch at the bottom. The gasket must be inserted into the groove of the
cover/strainer before reinstalling onto the suction fitting.
DANGER:
RISK OF SEVERE INJURY OR DROWNING!
Keep hair a
minimum of 6 inches (152 mm) away from the suction fitting at all times when the whirlpool system is operating. Hair
longer than shoulder length should be secured close to the head, or a bathing cap should be worn.
DANGER:
RISK OF SEVERE INJURY OR DROWNING!
Do not operate the Whirlpool system with the suction
cover/strainer removed! It is a safety device and must always be in place on the suction fitting to minimize the potential
hazard of hair and body entrapment.
Maintenance (Continued)
Whirlpool Suction Cover/Strainer Maintenance
Fig. 19
