Page 4
www.jacuzzi.com
Installation and Operation
English
Signature™ Collection
Signature™ Collection
Important Safety Instructions (Cont)
Inspection and Testing
All bathtub units are factory tested for proper operation and watertight connections prior to shipping. However, the unit
must be retested by the installer prior to installation. Jacuzzi Luxury Bath is not responsible for any defect that could
have been discovered, repaired, or avoided by following this inspection and testing procedure:
1
Place the bathtub on a level surface, near appropriate electrical supply, water supply, and water drainage. A
driveway is a suitable choice.
2
Cover the drain and overflow hole with tape or a stopper and fill the bathtub to the bottom of the overflow hole.
3
Allow bathtub to stand for 5 minutes.
4
Plug in motor/pump and turn unit on. Confirm that all features function as described in the Operation section of
this manual. Do not install the bathtub if bathtub fails to operate as described.
5
Visually inspect all joints for leaks. Do not install the bathtub if leaks are detected.
6
Return bathtub to box or otherwise protect from damage until time of installation.
1
Remove the bathtub from the shipping carton. Be careful not to scratch the surface of the bathtub on exposed
staples. Remove the staples or fold them into the carton. Retain the carton until satisfactory inspection of the
product has been made. Do not lift the bathtub by the plumbing at any time; handle by the shell only.
2
Inspect the shell and bathtub components. Should inspection reveal any damage or defect in the finish or visible
damage to any components, do not install the bathtub. Damage or defect to the finish claimed after the bathtub
is installed is excluded from the warranty. Jacuzzi Luxury Bath’s responsibility for shipping damage ceases upon
delivery of the products in good order to the carrier.
3
Refer any claims for damage to the carrier. For definitions of warranty coverage and limitations, refer to the
published warranty information packed with the product or in the back of this manual.
Visual Inspection
Bathtub Water and Operational Test
CAUTION
Keep body and hair a minimum of 6˝ (152mm) away from the suction fitting at all times when
the hydromassage system is in operation. Hair longer than shoulder length should be secured
close to the head.
CAUTION
Do not immerse the control panel by overfilling the bath.
CAUTION
To avoid injury, use care when entering and exiting the hydromassage bathtub.
CAUTION
Do not use drugs or alcohol before or during the use of a hydromassage bathtub equipped
with a heater. Possible drowning may occur.
CAUTION
Do not use a hydromassage bathtub equipped with a heater immediately following strenuous
exercise.
SAVE THESE INSTRUCTIONS.
The Company has obtained applicable code (standards) listings generally available on a national basis for products of
this type. It is the responsibility of the installer/owner to determine specific local code compliance prior to installation
of the product. The Company makes no representation or warranty regarding, and will not be responsible for any code
compliance. Product specifications are subject to change without notice.
CAUTION
Use this unit only for its intended use as described in this manual. Do not use attachments not
recommended by the manufacturers. Do not tamper with user-operated controls or such
devices.
CAUTION
Water temperature in excess of 104°F (40°C) may be injurious to your health. Check and
adjust water temperature before use.
