14
Alternate Use of Water Rainbow Spout as Fill Spout
You can use your Water Rainbow spout as a fill spout by permanently plumbing it to a fresh water supply if codes permit.
Local plumbing codes may require the use of an anti-siphon valve for such a connection. Do not interconnect water supply
with recirculating system of the spa.
To make the connections necessary to use the Water Rainbow as a fill spout, follow this procedure:
• Make sure power to the equipment pack is disconnected and spa is drained to below seat level.
• Cut 3/4" flexible piping as shown in illustration below and unscrew connecting fitting at spout.
• Cap off piping by cementing a 3/4" PVC cap where cut has been made.
• Connect permanent plumbing line to the spout.
FRONT ACCESS
SKIMMER/FILTER
Spa Set-Up
Remove the protective plastic rim cover on the
spa. Use care. Stepping into the spa with shoes
will scratch the acrylic surface.
Remove any packing materials from the spa.
Remove each filter cartridge and skimmer basket
from plastic bags.
Pull open each skimmer/filter door by the handle
located in the middle of the door. Insert the filter
cartridge into the filter housing and insert the
skimmer basket so it is in place over the filter
cartridge. Then close the skimmer/filter door.
Clean the interior of the spa of any remaining
construction debris. Remove stubborn stains,
paint or tar with turpentine, isopropyl alcohol or
paint thinner. A mild liquid dishwashing detergent
on a damp cloth is fine for cleaning off other dirt.
Plaster can be removed by scraping with a wooden
edge; do not use a metal scraper, wire brush, or
other metal tools, as they will damage the spa's
surface.
SKIMMER BASKET
WEIR DOOR
FILETR CARTRRIDGE
NYLON ROPE LOOP
INSTALL AND CEMENT3/4" PVC CAP
CUT PIPING HERE (LEAVE 1-1/2" -2")
TEE ON DISCHARGE PIPING
3/4" FLEXIBLE PIPING
SPA SHELL
WATER RAINBOW SPOUT
INSTALLATION
