REMEDY
PROBABLE CAUSE
PROBLEM
7. Water leakage at pump
shaft. (rotating connection
between pump and motor).
8. Motor will not start.
A. Worn or damaged pump seal.
B. Foreign matter trapped
in pump.
A. Optional timer or switch
set at OFF.
B. Circuit breaker tripped or in
OFF position.
C. Locked shaft or impeller.
D. Disconnected or defective
wiring.
E.
Defective starting switch inside
motor.
F. Motor winding burned out.
G.
Auxiliary switch malfunction.
A. *
B. *
A. Turn to ON.
B.
Reset circuit breaker.
C. *
D. *
E. *
F. *
G. *
9. Motor stops.
A. Optional timer or switch set
at OFF.
B. Circuit breaker tripped or in
off position.
C. Switch failure.
D. Motor overload condition.
E. Auxiliary switch malfunction.
A. Turn to ON.
B. Turn to ON.
C. *
D. Let cool for one hour. Motor
overload will reset, then start
again. If problem persists,
contact your Jacuzzi Whirlpool
Bath dealer for service.
E. *
10. Will not hold prime.
A. Air leak through faulty or
open vent valves.
B. Water or air leak in system
plumbing.
C. Low water level.
D. Faulty check valves.
A. Close or repair vent valve.
B. Repair leak.
C. Fill spa to middle of skimmer
opening.
D. Replace valves.
26
* Note: The skills and tools necessary for the safe repair of this spa require the services of qualified service personnel.
Contact your Jacuzzi Whirlpool Bath Authorized Service Agent or Dealer.
TROUBLESHOOTING GUIDE
