19
9/10/15
If the base was powered scan the association barcode in the well of the base
between the Bluetooth disassociation switch and the charging contact pins. The
HS2R9 should then emit a clicking should for a short period while associating
with the Bluetooth module in the base. Upon a successful Bluetooth association
the HS2R9 will flash the green LED and emit a single short high frequency beep.
HS2R9 Scanner will not send data to the host:
If the HS2R9 is associated with the base but no data is being received by the
host system check that the USB driver is installed on the host and the base has
enumerated correctly.
Factory Contact:
If you are unable to resolve the problem with the HS2R9 after reading the
troubleshooting section please use the contact information in chapter 10 for
assistance.
Summary of Contents for Flexpoint HS2R9
