51
9/10/15
The unit can read both RFID and barcode, but not simultaneously. If the unit is not
triggered to read barcodes (top trigger button is not pressed or not serially triggered), the
unit will be in RFID mode actively scanning for RFID tags.
When the unit is triggered to read a barcode (top trigger button is pressed or serially
triggered), the RFID transceiver will be put into low power mode before enabling the
barcode scanner. Conversely either after a barcode scan or trigger release (manual or
serial), the barcode reader is put into low power mode before enabling the RFID
transceiver. When the RFID portion of the scanner is active it is attempting to read ISO
15693 tags as our current customer requirements are only for that tag type.
Alternating the operational modes described above reduces current draw to extend
battery life. The beeper is also only activated after the barcode reader is off to keep
current draw at a minimum.
NOTE:
A special version of firmware was developed for the HS2R9 specifically for
agency RFID modular testing. This firmware allow for independent selection of one of
four different tag types which encompass the four different modulation techniques of the
transceiver. When any one of these four different modes is selected, this is the only
modulation technique active, and the HS2R9 will then only read that specific tag type.
HS2R9 Technical Description
The HS2R9 consists of four subsections:
1 – Barcode scanner.
2 – RFID transceiver and antenna (transceiver is NXP CLRC663).
Summary of Contents for Flexpoint HS2R9
