HS-1RS User’s Manual
Page 22
* Don’t Vibrate
Vibrate on Good Read
Trigger Commands
In order to scan barcodes, you need to ‘trigger’ the HS-1RS.
This can be done in various ways. You can activate the HS-1RS by sending the trigger
command
TRGON
serially or by pressing the trigger button on the scanner itself.
Several supporting commands are provided to set the allowed trigger time-out (e.g. the
maximum time that the scanner will take to keep looking for a barcode.)
TRGON
This command turns the trigger ON.
TRGOFF
This command turns the trigger OFF.
Trigger Modes
Manual Trigger (level)
You can activate the imager by pressing the trigger or sending the serial trigger command
TRGON
. When in manual trigger mode, the HS-1RS scans until a bar code is read, until
the trigger is released, a
TRGOFF
command is sent, or a time-out occurs.
Use the command below to enable Manual Trigger Mode.
* Manual (level) Trigger
Presentation Mode
Presentation mode is a hands-free mode of operation in which the imager will
automatically trigger on when an object is moved into the field of view.
The HS-1RS will not enter low power mode while in Presentation Mode.
Use the command below to enable Presentation Mode.
Presentation Mode
