HS-1RS User’s Manual
Page 30
RFID Time Out
This sets the time out period for RFID read and write operations. If such an operation does not
take place within the programmed period, a time out message will be sent by the HS-1RS.
Several commonly used RFID Time Out menu command barcodes are included below.
Use the command
RFIDTMO
x
(where ‘x’ is a value between 0 and 65535)
, to set the time
between 0 (no delay) and 65535 (=~65.5 seconds) in steps of 1ms, or by building a menu
command barcode.
Please contact JADAK if assistance is needed. Default time = 1000 (1.0 second).
Setting examples:
* RFID Time Out 1.0 seconds
RFID Time Out 2.0 seconds
RFID Time Out 5.0 seconds
RFID Time Out 10.0 seconds
RFID Re-read Delay
This sets the time period before the HS-1RS can read the same RFID tag a second time.
Setting a proper re-read delay time protects against accidental re-reads of the same tag.
Several commonly used re-read delay menu command barcodes are included below. Use the
command
RFIDDLY
x
(where ‘x’ is a value between 0 and 5000)
, to set the time between 0 (no
delay) and 5000 (=5 sec.) in steps of 1ms, or by building a menu command barcode.
Please contact JADAK if assistance is needed. Default time = 1.0 seconds.
Setting examples:
No Re-read delay
Re-read delay 0.5 seconds
* Re-read delay 1.0 seconds
Re-read delay 2.0 seconds
