7
TRIAL OPERATION AND MAINTENANCE
Normal phenomenon
Put a wet towel on sensor area
Once finished with connection of water supply, open the angle valve and switch
on the power.
The magnetic valve will flush the toilet and the nozzle will come out. This is
the self-inspection process. The water temperature indicator flashes which
means the water tank is getting water and after 40 seconds the indicator will
stop flashing, which means finish water input. (It is normal for the nozzle to
delay spraying for 10-15 seconds on the first time use)
NOTE: It is normal phenomenon for the nozzle to come out and spray
opening the angle valve and getting the water supply. After power is on, the
nozzle will go back and stop spraying.
Function confirmation
1. Please check each function according to the manual.
2. Switch on the power and put a wet towel or cloth on sensor area. After 1
minute, the water will be heated at set temperature and the warm air will
work when you press the “Dryer” button.
3. When there is no power supply, no function can work except
the non-electric flush.
Pair remote controller when seated on the toilet:
STEP 1: Keep pressing side button for 5 seconds until you hear “BEEP”, the LED
display will blink at the same time, now the toilet is waiting to pair.
STEP 2: Press any button on the remote controller, will hear “BEEP”, and LED
display will stop blinking, pair finished.
The remote control should already be paired.
Only need to pair if setting up a new remote control.
Main body cleaning
Clean with sponge or soft dry cloth with mild detergent.
NOTE: Do not use thinner, benzolin, detergent, chemical, pesticide or
deodorant to wipe.
Nozzle cleaning
1. Please clean the nozzle frequently. Press “Front wash or Rear wash”
button when no body seated so that the nozzle will come out. Then clean
it with toothbrush or soft cloth.
2. Please don’t over pull the nozzle. Press the “Stop” button after finished
cleaning so that the nozzle will go back automatically.
Filtering mesh cleaning
1. Stop the water supply.
2. Open the T-joint water input cap.
3. Take out the filtering mesh and clean it with
toothbrush.
4. Put it back and recover the water supply.
Not use for long time - Drainage
1. Stop the power supply.
2. Stop the water supply.
3. Lift up the main body.
4. Screw out the drainage screw and drain out water.
5. Put the drainage screw back.
