Page 3
WEIGHING SCALE
D. Wind Shield
Note: Always reinstall the transportation protection device before transporting the scale, lest the precision
sensor should be damaged due to bumping and falling during transportation.
IV. PRECAUTIONS
1.
Full charge the battery after unpacking the scale.
Recharge the battery
: When battery symbol appears on the LCD display, charge the battery with AC power cord
plug in, the indicator of charge will light up in red; when it becomes green means charge completed. (It takes
about 8 hours to full charge the battery.)
2. Install the equipment on a level and stable surface.
3. Do not install the equipment near the air conditioning or a vibrating machine.
4. Install the equipment in an environment with steady temperature (0
℃
~40
℃
), avoid rapid
temperature changes.
5. Independent AC outlet for this equipment is recommended, check the voltage before plug in.
6. Warm up the equipment for 15 minutes before use.
V. KEYPAD
1.
“
＂
Press PRINT key, RS-232 will print data, when negative value is shown on the screen, the
printing function is prohibited.
2.
“
MODE
＂
Press MODE key for selecting weighing unit.
3.
“
TARE
＂
Press TARE key for deduction of current weight on the weighing pan. After removing the weight
on the weighing pan, press TARE key to cancel the original tare.
Note: This operation can only be performed in the stable mode.
4.
“
ZERO
＂
Press ZERO key and the screen will show zero
0.0000
, press ZERO key in the tare mode, the tare
will be cancelled; if the weight on the weighing pan is within the zero adjustment range, the
scale will be reset to zero.
5. “ON/OFF”
Power switch.
