1
Turn off hot and cold water
supplies before beginning.
CAUTION
ROUGHING-IN
DIMENSIONS
1 0 9 6 2 4
1 0 9 6 2 4
INSTALL WALL SUPPLY
6-1/4"
2-3/8"
1"
7-3/4"
1-3/4"
2-3/4" D.
Plumbers' Putty or Caulking
Adjustable Wrench
Phillips Screwdriver
Channel Locks
TOOLS REQUIRED
Regular Screwdriver
859/O23/...
86O/1O3/...
826/999/...
WALL SUPPLY
WITH BUILT IN
BACK FLOW
PREVENTER
1/2
1-1/16"
1/2
N.P.T.
(48" - 60") (OPTIONAL)
TO FINISHED FLOOR
(48" - 60") (OPTIONAL)
TO FINISHED FLOOR
(48" - 60") (OPTIONAL)
TO FINISHED FLOOR
(8" - 24") OPTIONAL
RUBBER GASKET
FINISHED
WALL
FINISHED
WALL
FINISHED
WALL
1/2 NPSM HOSE
CONNECTION
1/2" NPT
APPLY SEALANT
1
1
2
The wall mounted SHOWER HOLDER (1, 14) works best if secured to a wall stud or cross brace within the wall, using
SCREW (2) supplied.
Supply to WALL SUPPLY (1) is 1/2" NPT. See rough-in above for detailed information.
Install RUBBER SEAL (2) onto WALL SUPPLY (1).
Apply sealant or teflon tape to threads of 1/2" NPT supply nipple. Thread WALL SUPPLY (1)
onto supply nipple making a water tight seal. WALL SUPPLY (1) with RUBBER SEAL (2)
should be tight against finished wall.
If the SHOWER HOLDER (1, 14) is to be installed on a tile or plaster wall the ANCHOR (3) and SCREW (2) should be used.
SHOWER HOLDER (1):
Frist unthread counter-clockwise HOLDER ASSEMBLY (4) and remove WASHER (5) and SPRING (6).
Secure HOLDER ESCUTCHEON (7) or SHOWER HOLDER (14) to wall with SCREW (2).
Assemble SPRING (6) and WASHER (5) and thread HOLDER ASSEMBLY (4) onto HOLDER ESCUTCHEON (7).
Note: Large side of WASHER (5) should face against ball of HOLDER ASSEMBLY (4).
For installations on drywall or tiled walls:
Use ANCHOR (3) and SCREW (2) for securing SHOWER HOLDER (1, 14) to finished wall.
Drill 1/4" dia. hole a minimum of 1-3/4" deep. Insert the ANCHOR (3) flush with face of the finished wall.
Determine desired height and location (optional) and mark a center line. If secured to a stud or cross brace drill small pilot hole
for SCREW (2).
2
3
INSTALL HAND SHOWER HOLDER
INSTALL HOSE AND HAND SHOWER
11
13
12
8
10
9
2
Install SEAL (8) into COUPLING NUT (9). Connect COUPLING NUT (9) to WALL SUPPLY NIPPLE (10) and tighten.
INSTALL second SEAL (11) into SPRAY HOSE END (12 ) and connect HAND SHOWER (13) to SPRAY HOSE END (12).
Hand tighten.
59"
2-3/16" D.
(48" - 60") (OPTIONAL)
TO FINISHED FLOOR
6
5
4
7
3
6-1/8"
4-5/16"
7-7/8"
3
2
14
11
13
12
Teflon Tape
