1
INSTALL LAVATORY
FAUCET
Turn off hot and cold water
supplies before beginning.
CAUTION
Installation Instructions
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
© J A D O U S A 2 0 0 7
P r o d u c t s
L u x u r y F a u c e t s a n d A c c e s s o r i e s
JADO USA
6615 West Boston
Chandler, AZ 85226
Phone:(800) 227-2734
Fax: (800) 552-JADO(5236)
www.jadousa.com
H 9 6 5 5 9 4
H 9 6 5 5 9 4
H 9 6 5 5 9 4
H 9 6 5 5 9 4
4
HELPFUL HINTS FOR CLEANING AND MAINTENANCE
The solid brass product you have just purchased has been designed to give you years of beauty and service. It is
important to bring to your attention proper care and maintenance procedures, which will ensure its lasting beauty.
First and foremost, it is important (as it is with any fine piece of jewelry or furniture) that the product be wiped clean and
dry with a soft damp cloth after every use.
Second, under no circumstances should an abrasive cleaner or combination cleaner/polish be used on JADO products.
The abrasive nature of such products will eventually destroy the finish and void the warranty.
In the event of stubborn blemishes shown on the finish, we recommend use of Windex window cleaner with a soft cloth,
but we do not recommend it be used on an everyday basis.
It is important to note that it is normal to expect signs of usage over time.
Thank you for selecting JADO for your home.
Single Lever Kitchen Faucet
Adjustable Wrench
Phillips Screwdriver
Channel Locks
Recommended Tools
Tubing Cutter
Regular Screwdriver
2
Product Numbers
832/800/...
Teflon Tape
WATER SUPPLY CONNECTIONS
1
1
3
2
COLD
HOT
3/8" COMPRESSION
14-3/16"
(360mm)
20-11/16"
(525mm)
1"D.
(26mm)
7-7/8"
(200mm)
2-5/16" MAX.
(59mm)
2-5/8" MAX.
(67mm)
MOUNTING
SURFACE
11-1/16"
(281mm)
3-7/16"
(87mm)
2-3/8"
(59mm)
ROUGHING-IN DIMENSIONS
IQ
™
GROOVE IN
(FAUCET BASE)
SWIVEL
SPOUT
MOUNTING
SURFACE
3
2
1
4
10
5
6
7
8
COLD
(OFF)
HOT
9
Seat O-RING
(1)
into under side of ESCUTCHEON RING
(2)
.
Feed FAUCET SUPPLIES
(10)
through the mounting hole and
install
the FAUCET
(3)
into the sink or counter top.
Assemble the two BRASS SCREWS
(4)
into the RETAINING
LOCKNUT
(5)
.
Assemble SUPPORT PLATE
(6)
with collar facing down onto SPOUT
SHANK
(7)
. Assemble RUBBER WASHER
(8)
, BRASS WASHER
(9)
and RETAINING LOCKNUT
(5)
onto FAUCET SHANK
(7)
from
underside of sink or countertop.
Align and center FAUCET
(3)
. Tighten LOCKNUT
(5)
on SHANK
(7)
.
Tighten the two BRASS SCREWS
(4)
to secure FAUCET
(3)
to
mounting surface.
3a
CHECK DRAIN CONNECTIONS
Note: Drain not included with fitting and must be
purchased separately.
Rotate STRAINER
(4)
to fill sink with water.
Rotate STRAINER
(4)
and drain water from sink.
Check all drain connections for leaks.
Tighten connections if necessary.
3
TEST INSTALLED FAUCET
AND CHECK FOR LEAKS
With HANDLE
(1)
in OFF position, turn on WATER
SUPPLIES
(2)
and check connections for leaks.
Remove AERATOR
(3)
.
Operate HANDLE
(1)
to flush water lines thoroughly.
Replace AERATOR
(3)
.
HOT
2
COLD
3
4
TO THE PURCHASER OF JADO BRASS PRODUCTS
Attention installer:
Please leave This Pamphlet for The Owner
POLISHED BRASS AND CUSTOM FINISH WARRANTY
: A 1 YEAR LIMITED FINISH WARRANTY from date of purchase is provided to the
first residential owner against defects in materials and workmanship. Due to the ever-changing finish of Patina products, the finish warranty
is excluded. Warranty shall not include problems related to the installation of the product.
MECHANICS
MECHANICAL WARRANTY:
A LIFETIME LIMITED WARRANTY is provided to the first residential owner on parts to be free from failure
related to defects in materials and workmanship but not installation.
CONDITIONS TO WARRANTIES
JADO Bathroom & Hardware Manufacturing Corp. places the following conditions on its finish and mechanical warranties to the first residential owner only.
JADO finish and mechanical warranties are limited to products correctly installed and used in a residential environment.
JADO warranties will not assume liability for damage due to abuse, mishandling, incorrect installation, improper maintenance, or deterioration
due to normal use.
JADO will not be liable for labor or other costs relating to the sale, installation, or replacement of their products.
In the event of a defect in any JADO product covered by this warranty, the product must be returned to the dealer where originally purchased
along with proof of purchase.
JADO's obligation under the warranty shall be limited to the repair or exchange of any product which has been determined by JADO to be
defective after appropriate examination.
The state of California has mandated under Proposition #65 that
manufactures of products, including faucets which come into
contact with potable water, must warn the consumer if the product
contains materials listed by the state as a carcinogen or
reproductive toxin. Lead, which is contained in all brass faucets in
limited amounts appears on the State's list.
Preliminary industry tests have indicated that users of faucets
made from brass face no significant danger, however,
California Proposition #65 requires that we provide you with the
following notice:
NOTICE: JADO products conform to industry
requirements of water conservation under the
ASTM / ANSI A112.18.1M-1994 plumbing code.
Lavatory, bidet, wet bar and kitchen faucet sets
have a maximum flow rate of 2.2GPM. Shower
heads, hand showers and body sprays have a
maximum flow rate of 2.5GPM.
Warning: This product contains an element
known to the State of California to cause cancer
of reproductive harm.
JADO BATHROOM AND HARDWARE MFG. CORP.
6615 West Boston
Chandler, AZ 85226
JADO warrants this product to be free from defects in materials or workmanship for as long as the original consumer purchaser
owns their home.
JADO will provide, free of charge, at it’s sole option, replacement part(s) or product (or if no longer available, a comparable
product) to replace those which have proven defective in materials or workmanship.
Proof of purchase (original sales receipt) from the original consumer purchaser must be made available to JADO for all limited
warranty claims. This limited warranty is non transferable. It does not apply in the event of product damage due to the use of other than
genuine JADO replacement parts, installation error, abuse, misuse, or improper care and maintenance (whether performed by
a plumber, contractor, service provider or member of the purchaser’s household). The limited warranty excludes damage due to aggressive
air or water conditions, or harsh or abrasive cleaners and/or materials. This limited warranty excludes all industrial, commercial and business
usage, whose purchasers are hereby extended a two year limited warranty (with the exception of solenoid valves and other electronic
components which carry a one year limited warranty) applying to all other terms of this limited warranty except duration. This limited warranty
does not cover labor charges incurred and/or damages sustained in installation, repair or replacement, nor incidental or consequential
damages, all of which are expressly disclaimed. This limited warranty is applicable only to JADO faucets manufactured after June 1, 1996
and installed in the United States and/or Canada.
This limited warranty gives the original consumer purchaser of an JADO faucet specific legal rights which may vary from state to
state or from province to province. This limited warranty does not cover any liability for consequential or incidental damages, all of which
are hereby expressly disclaimed, or the extension beyond the duration of this limited warranty of any implied limited warranties, including
those of merchantability or fitness for an intended purpose. In some states or provinces the exclusion or limitation of incidental or consequential
damages is not allowed, so those exclusions may not apply to you.
JADO Bathroom & Hardware Manufacturing Corp. provides the following warranties only to the first residential owner of our products.
FINISHES
JADO FAUCET LIFETIME FUNCTION AND FINISH LIMITED WARRANTY
Note:
FLEXIBLE HOSES
(1, 2)
on FAUCET
(3)
are 20-11/16" (525mm)
in length from base of faucet. If longer supply length is required
installer must purchase adapters and additional supplies to
complete connections.
Important: If SUPPLY HOSES
(1, 2)
are to long, loop as
illustrated to avoid kinking.
Connection on FLEXIBLE HOSES
(1, 2)
is 3/8" compression. Connect
left supply marked (RED) to Hot and right supply marked (BLUE) to Cold
wall supply.
Use adjustable wrenches to tighten connections. Do not
over tighten.
Complete all drain connections to sink and waste outlet.
BLUE
RED
20-11/16"
(525mm)
HOSE LENGTH
3/8" COMPRESSION
