Hold the case in one hand,
with the watch placed crystal
down on a support.
With the other hand grip the
"fork" tool supplied with the
watch, and slide it between the
horn and wristlet, in order to
grip the wristlet bar between
the teeth of the fork.
Make sure that the tool is cor-
rectly positioned on the bar,
on the retractable end of its
spindle.
The bar is equipped with a
spindle mounted on a spring,
which needs to be released. To
do so, press the tool onto the
bar's retractable end, sliding it on
laterally (from the end opposite
the horn) to act on the spring.
Once the spring has been
released, take out the bar,
and pull the wristlet section
towards you to extract it.
Retractable end
of the bar
Dismantling and reassembling wristlets
To alter the wristlet of your Master Compressor Diving, you
can remove and refit the wristlet sections.
Dismantling the wristlet
Reassembling the wristlet
Insert one end of the bar into
the hole in the horn of the
case, and hold it firmly.
Take the tool supplied, and
position it on the free retract-
able end of the bar. Holding
the tool in this position, press
sideways (from the end oppo-
site the horn) to push the
spring back inside the bar.
Move the retracted bar to
over the housing hole in the
horn, and release it so as to
engage the spring.
Make sure that the wristlet
is properly fitted by pulling
gently on the section.
M
aster
C
oMpressor
D
iving
p
ro
g
eographiC
- English
7/9
