jaga
|
CLIMA CANAL WITH JDPC installation instructions
55
EN
CHANGING FACTORY DEFAULTS
The factory settings of the JDPC-module ensure a confortable operation of the device. the jdpc mo-
dule is located under the valve cover plate.
How to change the minimum temperature setting?
Press and hold the
button unti
the
red LED
fl ashed 5x and release.
Exit setup mode by holding the
button until
the
red LED
fl ashed 5x and release.
The fan will start at this temperature. With a higher setting of the water temperature, the fan
will start later. At a lower setting, the fan will start earlier. When using a heat pump, it may be
necessary to set the water temperature at a lower setting.
SETTING: MINIMUM TEMPERATURE: HEATING - Factory Presetted: 28°C
24°C
26°C
28°C
30°C
32°C
34°C
36°C
38°C
I
- 2°C
+ 2°C
I
Press briefl y on the
button or the
button to decrease or increase the water
temperature by 2 degrees.
Indien de maximum
temperatuur is bereikt,
de rode LED knippert
snel.
If the minimum
temperature is reached,
the bleu LED fl ashes
rapidly.
The JDPC controller returns into normal mode after 30" and will automatically save all modifi ed settings !!
5x
5x
-
+
+
-
+
+
-
+
+
-
+
EN
conf
onfort
ort
a
abl
e
ope
r
rat
ion
n
o
of th
e d
e d
e
ev
ice
. t
he
jdp
jdp
c m
o-
-
OPTION 01
(DPC.CC21/DPC.CC22)
: JDPC.002 WITHOUT CONTROL PANEL
OPTION 02
(DPC.CC24/DPC.CC25)
: JDPC.002 WITH CONTROL PANEL
OPTION 03
(DPC.CC71/DPC.CC72)
: JDPC.002 EN 0-10 VDC INPUT FOR DOMOTICA
Automatic control
: The
green LED
lights when the water temperature exceeds the set temperature.
This indicates that the supply water is hot.
