Dismantling
Item no. 10404083, Revision 01
31 ( 36 )
13
Dismantling
Proceed as follows to remove the HF spindle:
Ü
Completely disconnect the power supply.
Ü
Completely disconnect the media supply (air and liquid).
Ü
Make sure that the shaft of the HF spindle has come to an absolute stand-
still.
Ü
Remove all connections from the HF spindle.
Ü
Empty the cooling duct of the HF spindle.
Ü
Remove the HF spindle from the machine.
13.1
Disposal and environmental protection
More than 90% of the materials used in the HF spindle can be recycled (alu-
minum, stainless steel, steel, copper, etc.)
The HF spindle may not be disposed of with normal domestic waste.
Ü
Remove all non-recyclable materials.
Ü
Dispose of the HF spindle as scrap at an approved recycling facility.
Ü
Follow all rules of the responsible administrative bodies.
Ü
Do not discharge coolants into wastewater.
Ü
Dispose of cooling media in accordance with local regulations.
If the HF spindle cannot be dismantled, send the HF spindle to
Nakanishi
Jaeger GmbH
.
Nakanishi Jaeger GmbH
shall not assume the costs incurred
for shipment and the fees for the recycling facilities.
14
Service and repairs
DANGER: Electric shock.
Electric shock can lead to severe burns and life-threatening injuries.
Take measures to prevent hazards caused by electrical energy (for details re-
fer e.g. to the regulations issued by the VDE and the local energy supply
companies).
u
Before commencing work, switch off the power supply of the HF spindle.
Note: Damage due to electrostatic discharge.
Do not touch the electrostatic-sensitive components of the HF spindle.
14.1
Service partners
Only certified service partners may open and repair the spindle. Failure to
comply with this voids any warranty claims and compensation claims for dam-
ages.
Ü
The list of partners can be found on the following website.
https://www.nakanishi-jaeger.com/en/contact/service-partners
