Tool change
Item no. 10204039, Revision 07
26 ( 36 )
10
Tool change
CAUTION: Danger of being drawn in by rotating shaft.
If the shaft is still rotating, fingers and hands may be drawn in and crushed.
u
Only change the tool if the shaft is at a standstill.
Example of design: Inserting the
shank
Note: Ensure functionality.
u
Never operate the HF spindle without a clamped tool shank.
If no tool shank is clamped:
q
The clamping system is damaged by the centrifugal forces.
q
The clamping system is shifted.
q
The balance of the HF spindle is affected.
q
The bearing is damaged.
10.1
Clockwise and counter-clockwise
Sample illustration:
Direction of rotation indication
The HF spindle clamping system is designed for clockwise and counter-clock-
wise rotation.
Ü
Only use tools with the correct direction of rotation for the HF spindle.
Ü
Only use tool mounts with the correct HF spindle direction of rotation.
Ü
Set the HF spindle direction of rotation on the FC to match the direction of
rotation of the tool / tool mount used.
10.2
Manual hollow shank taper
1
Clamping segment
2
Access hole
3
Locking ring
4
Threaded spindle
5
Marking "X"
6
Snap ring
7
Ejector with withdrawal thread
8
Basic body
9
Driver
10
Cam
11
Shaft of HF spindle
12
Mounting spindle
