Jägermeister SHOTMEISTER, Owner'S Manual

5

Pouring Shots from your 

Shotmeister Machine

When pouring ice cold shots from your Jägermeister Shotmeister, pull 

the tap handle towards you. When done pouring, push the tap handle 

back to the center position, ensuring the valve is closed.

Note: If the tap handle is not completely vertical, Jägermeister may 

continue to flow from the tap in a slow stream.

Cleaning Instructions

1.

  Turn off machine and remove the bottle

2.

  Drain remaining Jägermeister liqueur from the machine

3.

  Fill empty Jägermeister bottle with warm water, install a bottle  

stopper, and insert into machine

4.

  Pull on tap handle and drain out all warm water from bottle

5.

  Repeat step 4 until the water exiting the machine is clear

6.

  Remove drip tray and tip machine towards you, raising the back a few  

inches, pulling the tap handle to ensure all water has drained from 

the machine

7.

  Make sure to clean all used bottle stoppers

Note: Cleaning should take place after machine has not been used 

for an extended period of time, or once every 6 months.

RETAIN YOUR ORIGINAL BOX AND PACKING 

MATERIALS FOR A PERIOD OF 1 YEAR.  

THESE ITEMS ARE NEEDED IF YOUR FREEZER 

REQUIRES SERVICE OR REPAIRS. 

For information on requesting service or repairs, visit:

www.tapmachine.com

In Case of Frost

It is normal for frost to appear in the freezer. To remove the layer

of frost, simply turn off the freezer and let it sit while the frost melts.

The frost will automatically drain out of the freezer. It is recommended you 

place a towel under the freezer in case of seepage.

It is normal to experience a layer of frost up to 1/8" inch thick.

ALWAYS CHECK TO MAKE SURE THE LID IS CLOSED FIRMLY