GO-5000M-PGE | GO-5000M-PGE-UV | User Manual (Ver. 2.0)
Main Functions
- 30 -
Main Functions
This chapter describes the camera's main functions.
Digital IN/OUT Interface
On this camera, the software control tool can assign the necessary signals used in the system to
digital inputs and outputs.
Line Selector
In the Line Selector, the following input and output signals can be assigned.
Line Selector Item
Description
Line 2
Optical Output1 from #3 of DC In/Trigger 6-Pin on the rear
Line 3
Optical Output 2 from #4 of DC In/Trigger 6-Pin on the rear
Line 5
Optical Input 1 from #2 of DC In/Trigger 6-Pin on the rear
TimeStampReset
This line is used to reset the Timestamp.
NAND 0 IN 1
No. 1 input to the first NAND gate
NAND 0 IN 2
No. 2 input to the first NAND gate
NAND 1 IN 1
No. 1 input to the second NAND gate
NAND 1 IN 2
No. 2 input to the second NAND gate
Line Source
Line source signal can be selected from the following table to connect it to the line item which is
selected in the line selector.
Line Source Item
Description
Low
Connect Low Level signal to line item selected in Line Selector (Default setting)
High
Connect High Level signal to line item selected in Line Selector
Acquisition Trigger Wait
Connect Acquisition Trigger Wait signal to line item selected in Line Selector
Frame Trigger Wait
Connect Frame Trigger Wait signal to line item selected in Line Selector
Frame Active
Connect Frame Active signal to line item selected in Line Selector
Exposure Active
Connect Exposure Active signal to line item selected in Line Selector
FVAL
Connect FVAL signal to line item selected in Line Selector
