User Manual (Ver. 1.0) - Setting List
GOX-5105MC-PGE | GOX-8105MC-PGE | GOX-12405MC-PGE | GOX-16205MC-PGE | GOX-20405MC-PGE | GOX-24505MC-PGE
- 118 -
TransportLayerControl Item
Setting
Range
Default Value
Description
GevCCP
0
～
2
0:OpenAccess
Control access rights.
0:OpenAccess
- Access rights have not been obtained by the
application.
1:ExclusiveAccess
- Once the application has made this setting, no
other applications can control or reference the camera.
2:ControlAccess
- Access rights have been obtained by the
application. Other applications cannot control the camera, but can
refer to it.
GevPrimaryApplicationSocket
-
-
Returns the UDP source port of the primary application.
GevPrimaryApplicationIPAddress
-
-
Returns the address of the primary application.
GevMCPHostPort
-
-
Controls the port to which the device must send messages.
Setting this value to 0 closes the message channel.
GevMCDA
-
-
Controls the destination IP address for the message channel.
GevMCSP
-
-
This feature indicates the source port for the message
channel.
GevStreamChannelSelector
0
0
Selects the stream channel to control.
GevSCCFGPacket
ResendDestination
0: False
1: True
0: FALSE
Enables the alternate IP destination for stream packets
resent due to a packet resend request.
GevSCCFGAllInTransmission
0: False
1: True
0: FALSE
Enables the selected GVSP transmitter to use the single
packet per data block All-in Transmission mode.
GevSCCFGUnconditional
Streaming
0: False
1: True
0: FALSE
Enables the camera to continue to stream, for this stream
channel, if its control channel is closed or regardless of the
reception of any ICMP messages (such as destination
unreachable messages).
GevSCCFGExtended
ChunkData
0: False
1: True
0: FALSE
Enables cameras to use the extended chunk data payload
type for this stream channel.
GevSCPInterfaceIndex
0
0 (Fixed)
Index of the logical link to use.
GevSCPHostPort
-
-
Controls the port of the selected channel to which a GVSP
transmitter must send data stream or the port from which a
GVSP receiver may receive a data stream. Setting this value
to 0 closes the stream channel.
GevSCPSFireTestPacket
-
-
Sends a test packet. When this feature is set, the device will
fire one test packet.
GevSCPSDoNotFragment
0: False
1: True
1: TRUE
The state of this feature is copied into the "do not fragment"
bit of IP header of each stream packet. It can be used by the
application to prevent IP fragmentation of packets on the
stream channel.
GevSCPSPacketSize
1476
～
3976
1476
Specify the SCPS packet size (bytes).
