LED
Light
Status
Off
Power is off.
(Blinking amber (rapid))
Detecting link
❖ Blinks for 1 second even when detected immediately.
(Blinking amber (slow)）
Waiting for connection between device and host to be
established or for event (trigger, exposure pulse, etc.) to
occur.
(Alternating between green and
amber (slow)）
Sending connection test packet.
(Lit green）
Connection between device and host is established,
but there is no data being transmitted.
(Lit red interval 500ms）
An error occurred during data transmission (CRC error,
single bit error, etc. detected).
❖ Lights for at least 200 ms before errors are displayed
when multiple errors occur simultaneously.
(Blinking green (rapid)）
Connection between device and host is established,
and data is being transmitted.
(Red pulse (slow)）
No connection.
LINK
④ LINK LED 1
～
4
Indicates the connection status of the CoaXPress.
③ CXP (CoaXPress) connector 1
～
4
Coaxial cable for digital video output Connect.
(The camera connector (Amphenol RF 034-1028-12G equivalent) is used.)
SP-45000M-CXP4A/SP-45000C-CXP4A
The CxpLink Configuration supported by this camera is as follows.
CXP12_X4*, CXP12_X3*, CXP12_X2*, CXP12_X1*
CXP6_X4, CXP6_X3, CXP6_X2, CXP6_X1
・*The CxpLink Configuration (CXP12_X4, CXP12_X3, CXP12_X2, CXP12_X1) can only
be used with CXP 2.0. The CoaXPress frame grabber board used must support CXP 2.0.
When using a CoaXPress frame grabber board that does not support CXP 2.0, set the
CxpLinkConfiguration setting to CXP6_X4, CXP6_X3, CXP6_X2 or CXP6_X1.
・You can check the current CXP version in [CxpVersion Used] of [Transport Layer Control].
If [CxpVersionUsed] is CXP 1.1, you cannot use the CXP12 link configurations. Even if you
are using a CoaXPress frame grabber board that supports CXP 2.0, if [CxpVersionUsed] is
CXP 1.1, you may need to make settings on the frame grabber board side. For the
specific setting method, refer to the instruction manual of the frame grabber board to be
used.
・The CxpLinkConfiguration setting must match the number of CoaXPress cables that
connect the camera to the PC. For example, if it is CXP12_X4, connect all four. If the
number of connection cables is less than the setting, reset the CxpLink Configuration
setting according to the number of connection cables.
Caution
- 9 -
