SP-5000M-GE2 / SP-5000C-GE2
- 32 -
5.2.5 AUX Type 3 HIROSE 10-Pin connector (factory option)
Type: HIROSE 10-Pin Connector 3260-10S3(55)
Table 8. HIROSE 10P pin assignment
No
I/O
Name
Note
1
O
TTL OUT2
Line8
2
O
TTL OUT3
Line9
3
I
TTL_IN2
Line10
4
NC
5
GND
6
I
L
Line11
7
I
LVDS_IN1-
8
NC
9
GND
10
GND
5.3 Digital IN/OUT interface
In the SP-5000M-GE2 and SP-5000C-GE2, the digital IN/OUT capability in the software control tool
can assign the necessary signals needed for the system.
5.3.1 Line Selector
In the Line Selector, the following input and output signals can be assigned.
Table 9. Line selector
Note1: Select and connect the line source signal against the item selected in the line selector.
Note2: Line 8 and 9 are available if AUX Type 3 (Optional configuration) is selected.
5.3.2 Line Source
Line source signal can be selected from the following table to connect it to the line item
which is selected in the line selector.
Line Selector item
Description
Line 2 Opt 1 Out
Opt 1 output from # and #8 pins of DC In/Trigger 12-Pin on the rear
Line 3 Opt 2 Out
Opt Out 2 output from #9 & 10 pins of DC In/Trigger 12-Pin on the rear
Line 8 TTL 2 Out
TTL 2 output from #1pin “AUX” HIROSE 10-Pin on the rear (Factory option)
Line 9 TTL 3 Out
TTL 3
output from #2pin “AUX” HIROSE 10-Pin on the rear (Factory option)
NAND 0 In 1
First input at NAND first gate in GPIO
NAND 0 In 2
Second input at NAND first gate in GPIO
NAND 1 In 1
First input at NAND second gate in GPIO
NAND 1 in 2
Second input at NAND second gate in GPIO
