SW-4010Q-MCL-M52 User Manual (Tentative)
Preparation
- 36 -
Load the User Settings
1. Stop image acquisition. User settings can only be loaded when image capture on the
camera is stopped.
2. Specify the storage location (UserSet1 - UserSet3) using the
UserSetLoad
command and
read the settings of the camera.
Note:
When selecting
Default
for UserSetSelector, the factory settings are loaded.
For more information, see the following Short ASCII command table.
Item
Short ASCII
Command
Values
Command Examples
UserSetLoad
LD
0:Default (Default)
1:User1
2:User2
3:User3
LD=[Param.]<CR><LF>
LD?<CR><LF>
