SW-4010Q-MCL-M52 User Manual (Tentative)
Setting List
- 88 -
Pulse Generator Item
Setting Range
Default Value
Description
PulseGeneratorEndPointMs
(ms)
-
0.15
Set the start point of the Low interval in milliseconds.
When the counter reaches this value, the output will
be 0. The setting range varies depending on the
ClockPreScaler value.
PulseGeneratorEndPoint = 1/PulseGeneratorClock *
PulseGeneratorEndPoint
PulseGeneratorPulseWidth
(ms)
-
0.15
Display the High interval width of the pulse in
milliseconds. The duration between the Start Point
and End Point is calculated. The setting range varies
depending on the ClockPreScaler value.
PulseGeneratorPulseWidth = 1/PulseGeneratorClock
* (PulseGeneratorEndPoint -
PulseGeneratorStartPoint)
PulseGeneratorRepeat
Count
0 ~ 255
0
Set the repeat count for the counter. When this is set
to 0, a free counter is enabled with no repeat limit.
PulseGeneratorClear
Activation
0: Off
1: Level High
2: Level Low
4: Rising Edge
8: Falling Edge
0: Off
Set the clear signal condition for the count clear input
of the pulse generator.
PulseGeneratorClear
Source
-
0: Low
Select the count clear input signal source.
0: Low
1: High
7: ExposureActive
9: LVAL
10-13: PulseGenerator0-3
14-17: UserOutput0-3
20: Line4: TTL In1
21: Line5: Opt In1
23: Line7 - CC1
24: Line10: TTL In2
26: NAND0 Out
27: NAND1 Out
28: Line13: TTL In3
29: EncoderTriger
30: EncoderDirection
31: SWIRExposureActive
32: SWIRLVAL
Note:
(
※
)Disabled if the PulseGenerator is selected in
PUlseGeneratorSelector.
PulseGeneratorClearInverter
0:False
1:True
0:False
Controls if the pulse generator clear signal is inverted.
False means "Active High" and True for "Active Low".
PulseGeneratorClear
SyncMode
0:Async Mode
1:Sync Mode
0:Async Mode
Select the sync mode for the count clear input signal.
