7
RECYCLE
Separate collection. You must not discard
with usual household waste. If it is necessa-
ry to replace the machine, or if it is no more
use to you, do not discard it with household
waste. Make this machine available for sepa-
rate collection.
Separate collection of used machine and
packaging let you recycle materials and use
them again. Use of the recycled materials
helps prevent environmental pollution and
decreases the requirements for raw materi-
als.
At the end of their useful life, discard batter-
ies with a precaution for our environment.
The battery contains material that is danger-
ous to you and the environment. You must
remove and discard these materials separate-
ly at a equipment that accepts lithium-ion
batteries.
8
INSTALLATION
8.1
UNPACK THE MACHINE
WARNING
Make sure that you correctly assemble the machine before
use.
WARNING
•
If the parts have damage, do not use the machine.
•
If you do not have all the parts, do not operate the
machine.
•
If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
8.2
INSTALL THE BLOWER TUBE
Figure 2 - 3.
1. Align the grooves on the rear tube with tabs on the
blower housing.
2. Install the rear tube onto the blower housing until the tabs
engage the grooves.
3. Turn the rear tube in the direction of the arrow until the
two tabs lock into the positions.
4. Align the hole on the front tube with the tab on the rear
tube.
5. Install the front tube onto the rear tube until the tab lock
into the position.
8.3
INSTALL THE BATTERY PACK
Figure 4.
WARNING
•
If the battery pack or charger is damaged, replace the
battery pack or the charger.
•
Stop the machine and wait until the motor stops before
you install or remove the battery pack.
•
Read, know, and do the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
8.4
REMOVE THE BATTERY PACK
Figure 4.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
9
OPERATION
WARNING
Make sure the blower tube is in position before operation.
9.1
START THE MACHINE
Figure 1.
1. Pull the trigger to start the machine.
2. Pull the trigger fully to increase the speed.
3. Release the trigger to decrease the speed.
9.2
STOP THE MACHINE
Figure 1
1. Release the trigger to stop the machine.
NOTE
Wait until the engine stops after you stop the machine.
9.3
OPERATION TIPS
•
Blow around the outer edge of the unwanted materials to
prevent the unwanted materials from scattering.
•
Use rakes and brooms to clear the unwanted material
before you blow.
5
English
EN
