Jakson & Company JakPower Kirloskar Koel Green 2R1040 G1, Installation, Comissioning & Operator Manual

15

JAKSON & CO.

DO`s

Check fuel /coolant/lube oil level
Check for any leakage
Check electrolyte level in Battery, It should be between 1.23-1.28 kg/ltr
Check Fan belt tension
Check battery charger
Drain the water from fuel tank,weekly during winters
Check all nuts, Bolts, Engine/Alternator foundation bolts tightness at the time
of commissioning then monthly
Check for any loose connections at the time of commissioning then monthly
Use K-cool super plus, Lube K-oil Premium and spares as per KOEL specification and
purchase from authorized KOEL service dealer
Refer Engine maintenance manual for routine and daily maintenance check.
Study 'user manual' in detail before usage.
Keep good ventilation which is essential to keep the air,cool and clean.
Use appropriate tools and equipments which are required to carry ot any
service.
Ensure all nuts, screw, pipe, connections and covers are properly tightened
Ensure that sufficient diesel fuel ,oil in the tank & lube oil in the engine( for
specification, grade of oil & coolant refer to O & M)
Check the battery codition and connections
Check earthing of the generator set
Apply load on the genset gradually
Carry out maintenance repairs & overhauling of the genset as per
recommended schedules in the user manual
Call on the authorised service dealer for servicing & maintenance work.
Please refer maintenace maual before doing any maintenance work.
Cable entry hole, if not in use, should be properly closed.

DON`Ts

Do not Repair /Service any part when set is running.
Never operate the genset with any parts or ducting removed.
If any fault is traced, Do not attempt to start the genset unless fault is rectified.
Do not use start push button continously for more than 5 seconds.
Do not check lub oil, coolant level while DG set is running.
Do not change or modify any wiring, it may cause void of warranty. 
Do not turn off the fuel supply for stopping the genset unless any emergency.
Do not start genset on load.
Do not allow the genset to run idle for Long periods on no load.
Do not leave behind tools,waste cloth,loose wires etc, after repair or
maintenance work is completed near the genset. 
If the DG set is with AMF panel do not tuch live wire as Main supply is
available in circuit from AMF panel even if DG set is OFF.
Do not get the DG set repaired and serviced by any unauthorized person. It
may cause void of warranty. 
Do not add acid of any strength to the Battery, for topping up use distilled
water only.
Do not attempt to open the locked doors it can cause failure of door lock.

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø

Ø