TRAX Totalizer User’s Manual
4-2
5-1
Figure 4.1 — Loop Cable
Connecting to the Loop
The Totalizer is connected to the
Loop using the loop cable (shown to
the right) that was supplied with the
counter. This cable contains wires for
connecting one or two loops to the
totalizer.
Generally, the wires from the loop
cable are connected to the wires from
the loop itself using a terminal block.
The following color code is used for
the wires:
Loop 1
: Red & Black with Red Stripe
Loop 2
: White & Black with White Stripe
The connections from the individual loops do not have to be in a specific
order. For example, the red wire on the loop cable can be connected to
either wire from Loop 1.
After screwing the black connector of the loop cable to the Totalizer, con-
nect the wires of the loop cable to their corresponding loop, using the color
code above. The Totalizer can then be turned on.
Once on, the Totalizer will automatically begin to tune itself to the loops.
This process takes approximately 2 minutes.
The Totalizer will not begin
to record data until the tuning process is complete.
For Totalizers with external power, the loop cable will also contain a power
jack. The battery charger supplied with the Totalizer should be plugged into
this jack to supply power to the unit. To avoid damage to the Totalizer, only
use the supplied battery charger.
Summary of Contents for TRAX Totalizer
