11
GB
1. - 2. Assembly of the front axle
1.1
Using the spanner (16), loosen the nut on the lower ends of the front axle (12), see
illustration.
1.2
Using the spanner (16), loosen the nut on the steering linkage.
2.
Place the front axle (12) in the correct position as shown in the illustration. Secure the
axle on the left, right and steering linkage with one nut each.
3. Mounting the rear axle
1.
Loosen the nuts from the rear axle (13) and remove the washers.
2.
Guide the rear axle (13) he body and the left-hand gearbox. Make sure that the rear
axle protrudes the same distance on both sides.
4. Mounting the wheels
1.
Remove the nuts and the washer from the front axle (12) using the spanner (16).
2.
Now put the wheels (3)and one washer each on the front and rear axle (13) and secure
it with a nur. Align the lugs of the wheel covers (5) with the grooves of the wheel and
press firmly onto the wheels.
Caution: The ends of the rear axle should stick out the same length on both
sides. The gear shafts of all wheels must point inwards towards the body.
5. Mounting the steering wheel
1.
Remove the locking screw from the steering wheel (1).
2.
Connect the cable form the steering wheel to the cable from the model. Fit the steering
wheel (1) onto the steering column as shown and secure it with the locking screw.
6. Fitting the doors
Place the doors (7) in the appropriate position as shown in the illustration. Press the door
bolts (18) down from above through the door and body hinges. down.
ATTENTION:
Be sure to fit the doors on the correct side!
7. - 9. Assembling the trailer
7.
Put the plankse (9, 10, 11) together (see illustration)
8.
Position the plans so that the 10 pins match the recesses on the trailer. Press the
planks on until they snap into place
9.
Place the trailer on the chassis, align the holes of the trailer with the protruding
attachment points on the chassis and press it onto the chassis until it engages (note
that the respective indication arrow points in the same direction, L to L, R to R).
Make sure that it is positioned correctly. Refer to the illustration.
10. Mounting the seat
Position the seat (8) onto the body by inserting the pins on the seat into the body. Screw it in
place with two screws (15).
11. Bumper
Press the bumper (4) at the front of the body into position until it clicks into place.
12. Fitting the windscreen
Press the windscreen (6) into position until it locks into place. 13.
13. Opening the doors
Press the vehicle door switch and then pull the door outwards to open it.
14. Battery connection
1&2 Open the cover underneath the seat as shown in the illustration.
3. Connect the connectors. Be careful not to reverse the polarity.
4. Close the cover.
15. Charging Your Vehicle
•
The power swich must be turned in OFF position when charging.
•
The charging port is under the seat.
•
Insert the charger into the socket - the LED lights up green. Connect the charger to the
charging socket.
•
The LED on your charger lights up red as long as the battery is being charged. If the
LED lights green again, the battery is fully charged.
•
The charge time is 6 hours.
•
When the vehicle begins to run slowly, recharge thebattery.
•
Do not charge the battery more than once within 20 hours.
•
Charger and battery heat up during the charging process.
Warning!
•
The charger is not a toy. Only use the charger supplied.
•
The battery may only be charged by or under the supervision of an adult.
•
The terminals must not be short-circuited.
•
The charger must be checked regularly for damage to the cable, plug, housing and other
parts. If any damage is found, the charger must not be used until the damage has been
repaired.
•
Let the model cool off sufficiently after each use before putting it back into operation.
When using an additional batteries let it cool off for minimum 15 minutes until the
model is operated again. Overheating can damage the electronics or may result in fire.
•
Always disconnect the model from the charger immediately after charging. Always
disconnect the charger from the power supply immediately after disconnecting the
model. Inserting the rechargeable model or charger after charging will result in damage
tothe model, charger or the power supply (fire hazard).
•
Use the charger only in dry rooms.
Resettable fuse
The vehicle is equipped with a self-resetting fuse. When the
current exceeds a certain rating, the recoverable fuse will au-
tomatically cut off the power supply for 5 - 10 seconds, then
the current will be resupplied.
Warning!
Risk of fire. Do not bypass fuse. This may overload and
damage the elecrical system. Replace only with original
size and type.
Functions
1 Control board
2 Engine sound / next song button:
When adaptor port and MP3 have no external device input, short press this key will play engine
sound ; when adaptor port and MP3 is connected with external device, or under in FM mode,
short press this key to play next song. Long press the key to increase the volume.
3 Horn button
Short press the button to play the horn. long press the horn button can reduce the volume.
4 Foot pedal switch
Step on the foot pedal switch, the car will move forward, loosen the pedal, the car will stop.
5 Cup holder
Control board
1 FM radio search
In FM mode, press this botton will search the FM channel..
2 FM station
Press this button to enter the FM mode.
3 Switch between Music, flash driver and AUX
Press this button to enter the music mode. Can switch between different play modes.(Mudic,
flash driver, AUX)
4
Forward:
Press forward button, step on the foot switch the modell will move forward,
loosen the pedal the car will stop.
5
Reverse:
Press reverse button, step on the foot switch the modell will move reverse,
loosen the pedal the car will stop.
6 High/Low speed
Power on, by default, the forward speed is high speed, press the High/Low button can change
to low speed, press this button again, can change to high speed. For backward, there is only
one speed, the High/Low button is in invalid.
Important!
The vehicle must be stationary before changing direction or speed. Otherwise the gear
unit and/or the motor could be damaged.
7
|
/ V-Pevious / VOL down
Short press to play the last channel, long press to lower the volumen
8 Light switches
Power on, by default, the light is on, press the button to turn off the light.
9
|
/ V+Next / VOL up
Short press to play the next channel, long press to increase the volume.
10 Start/Stop
|
Long press to turn on or turn off the power; When the music or radio is on, short press can stop
it, short press again can restart play it.
11 USB
After inserting a USB stick, the soundboard starts playing the tracks one after the other. Only
files with the extension .mp3 can be played back.
12 Voltage display
Attention!
Your vehicle displays the total voltage of the two batteries in volts immediately after switching
on. The fully charged batteries will usually display a total voltage of approx. 12.6-13 volts
unloaded. The display is load dependent. This means that the displayed voltage will drop under
load. If a voltage of less than approx. 11.8V is displayed in the unloaded state, you should
switch off the Ride-on and charge the battery (see charging procedure). Otherwise the battery
may be deeply discharged and irretrievably damaged.
Otherwise, the battery may become deeply discharged and be irretrievably destroyed.
A deeply discharged battery is not covered by the warranty and must be replaced at
a charge.
13 Aux
Connect MP3 device / mobile.
14 Charging socket
