6
17. The next two fuselage frames are now placed between the
two side pieces and glued together.
Make sure they are straight!
18. If swimmers are mounted later on, the bottom fuselage cover
can be adjusted so that a second undercarriage wire can be
fitted later on.
19. The rear fuselage upper part, elevator and the last little piece
of plywood frame are glued. Now cut 15mm long stripes
from 4 mm balsa and stick to the edges. These should overlap
and be sanded later.
Tip:
Start at the front. Make sure no deformations aprear and if
they do, correct them.
21. Glue 3 mm balsa strips on top
20. The images shows the front underside. Sand down the edge
slightly.
22. Sand the surface round..
