Jamara Fokker DVII, Instruction

23

Take tail wheel, 2mm collar and M3x4 hex screw out of hardware 

bag. Install tail wheel to the tail gear and put on the collar. Keep 

the distance between the wheel and collar around 1.5mm and  

secure the collar in place with M3x4 screw.

Attach the clevises onto their respective horns on the elevator 

and rudder. Slide the silicone tube over the clevises for providing 

extra insurance against the clevises accidentally coming open.

Keep the distance between the end of the tubing and the end 

of rod around 15mm; us instant glue to secure the tubing on the

fuselage.

Pull the tubing through planking (in the front of the servo tray) 

tight and use instant glue to secure the tubing in place.

Drop some instant glue onto the servo securing holes on servo 
tray for reinforcing the securing ability when screw in.

Place the servos, rod connectors, plastic nuts and M3x4mm hex 

screws on the working table. Use 2mm driller to drill the out-most 

hole on the servo arm. Install the rod connectors into the out-

most hole and secure with plastic nuts and M3x4mm hex crews. 

Do screw too tight; make sure the rod connector can move freely.

Set the servos at neutral position and secure on the servo tray 

with provided screws. Release the hex screw and insert the rod 

through the rod connector. Keep the distance between the end of 

the rod and the end of the tubing around 15mm; set the elevator 

align to the horizontal and secure the rods by tightening the hex

screw. Set the rudder aligns to the vertical and secure the rod by 

tightening the hex screw.

Place the ESC, propeller, aluminum nut, motor and its relative 

accessories on the working table.

Place the cross metal mount on the fire wall and set the cross 

mark on the center position of the metal mount. Use maker to 

mark the out-most 4 holes on the cross mental mount.

Use 2.6mm driller to drill open the 4 marked holes on the fire wall. 

Drop dome instant glue into the holes for reinforcement.

Use hobby knife to cut off the center circle hole on the fire wall.

Secure the motor on the cross metal mount with provided 

screws. Connect the motor with ESC, set the ESC through the

hole on the fire wall and secure the ESC on the bottom of the 

fire wall with Velcro tape. Secure the motor onto the fire wall with 

3x16mm tapping screws.

COVERING AND FINISHING THE MODEL