7
Use wooden planning tool to trim the tips into V shape on H2
(angle is around 30 degree on one side).
Use sandingpaper to trim the surface. Don‘t trim too much.
Try to fit the hinges into the holes.
Close view of the V shape on the tip. It is also workable to use
sanding paper to trim the tips into V shape; but be careful, don‘t
trim too much.
Use sanding paper to trim the edges into round edges (R5).
Place V1 and H6 on the working table for assembling the vertical:
Place H2 and H3 combinations on the working table.
Close view of the round edges.
Try to fit the H6 into V1 and use instant glue to secure the H6
in place.
Try to fit the H6 into the slots on the H2; fit H7 into the slots on
the H3. Drop some instant glue to secure the H6 and H7 in place.
Don‘t secure H2 to H3 right now.
Try to fit the H2 into H3 and use instant glue to secure them
in place.
Please refer to the drawing on next step and mark the correct
locations for hinges on the elevator and horizontal. Use hobby
knife to cut the hole (width is around 0.5mm) for inserting the
hinge (0.35mm).
Use sanding paper to trim the surface:
ELEVATOR ASSEMBLY
RUDDER ASSEMBLY
Summary of Contents for Fokker DVII
Page 16: ...16...
Page 17: ...17...
Page 27: ...27 Ailerons Elevator Rudder Installation of Electrical...
