INSTALLATION GUIDE
®
SPL5
FLAT
MOUNTING BRACKET
Installation guide for James Loudspeakers SPL5 SoundBar series universal mounting bracket.
Swivel Joint should rest on the top of the
SoundBar. Secure and position flat mount
and spacer (Part F1 & F2) to align with
VESA through-hole pattern on the TV. Use
8-32 x 3/8˝ Phillips flat head screws (Part
T2).
4
5
6
Place the display on a padded flat surface.
Loosen screws on bracket (Part A) and
pre-assembled swivel joints, so that they
can slide/pivot with little resistance.
1
2
3
Determine the amount of spacers
needed (Part E). With or without the
spacer on the VESA pattern, the bracket
and slider should slide up and down
without interference from the SoundBar
or any protrusions on the rear of the
display.
Determine the screw size, M6 or M8,
required to mount your wall bracket to
the display. Select either the M6 (Part H)
or M8 (Part G ) hardware bag. 3 lengths
are provided, 35mm, 45mm, and 50mm.
Select the correct length to match the
spacer quantity (height), so the screw
properly holds the brackets and mount to
the display.
BRACKETS SUPPLIED HARDWARE
Part QTY Screws
E
28
Round Spacers (1.25˝ x 0.125˝)
G
4
M8-50mm Pan Head Philips Screws
4
M8-45mm Pan Head Philips screws
4
M8-35mm Pan Head Philips screws
H
4
M6-50mm Pan Head Philips Screws
4
M6-45mm Pan Head Philips screws
4
M6-35mm Pan Head Philips screws
J
4
UNC 1/4-20˝ Pan Head Philips Screws
4
UNC 1/4-20˝ Hex Nuts
Part QTY
Screws
8
No. 12 Wood Screws 1.75˝ Phillips Screws
T2 4
UNC 8-32 x 3/8˝ Flat Head Philips Screws
4
UNC 8-32 x 3/4˝ Flat Head Philips Screws
TV MOUNT SUPPLIED HARDWARE
Part F2
(2) Flat Mount
Spacers
Part F1
(2) Flat Mounts
Part T1
(2) Tilt Mounts
Part A
(Pre-Assembled)
(2) Fixed brackets, (2) Sliders,
(2) Short swivel joints (part B),
(2) Long swivel joints (part C)
Part C
(2) Additional
Long
Swivel Joint
Part B
(2) Additional
Short
Swivel Joint
Position SoundBar evenly below the display.