943-M36-BNK RADIANCE MIRROR
Made in China
Page
5
of
6
Version:202107
KLQA5E1S58989H1B1P1
ELECTRICAL SAFETY INSTRUCTIONS:
All connections must be installed by a licensed electrician, in accordance with current building codes. Consult a qualified
electrician.
IMPORTANT:
Always switch off the electrical supply at the main during installation and maintenance. It is recommended that the circuit
breaker is switched off for the necessary circuit before installation commences.
Fitting in Bathrooms is subject to the appropriate building code Regulations. This product is NOT suitable for outside zones. It is
also Not suitable for installation in saunas, steam rooms or shower cubicles. This product is only suitable for permanent
installation.
DO NOT
connect to a trailing plug and socket outlet. This product is only suitable for indoor use. Do not attach the
product to surfaces that are damp or otherwise electrically conductive.
INSTALLATION CARE & SAFETY:
Wear suitable eye protection when drilling. Take care when using power tools. Beware of hidden cables or pipes. Take care if
drilling on tiled surfaces in case the drill slips. A piece of masking tape applied to the wall before marking out the fixing holes will
stop the drill from wandering.
CLEANING:
It is recommended that the unit is cleaned with a soft,dry, non abrasive cloth when turned off. Never use cleaning agents or
abrasive materials on any type of surface finish. Do not allow moisture to come into contact with the electrical components.
IMPORTANT:
DO NOT strike glass components with hard or pointed items. DO NOT place very hot or very cold items against or in close
proximity to glass surfaces unless an adequately thick insulation material is used to prevent such items coming in contact with
the glass. The nominal thickness of the mirror glass used in this product is 1/
5
” and is film backed for safety. If the glass
becomes chipped or broken replace immediately.
MANUAL INSTRUCTION
：
1) Short Touch the switch button (＜1s) to turn the light and defogger ON/OFF.
2) Long Touch the switch button (＞1s) to activate the dimming function. Adjust the light to the appropriate brightness.
