SONIC D SERIES
OPERATION INSTRUCTIONS
1)
Check the specification table for the correct operating requirements
(located on the rear of the unit).
2)
Before connecting power, put the unit on a stable and flat working surface.
Add water to tank, sufficient to completely immerse the items being cleaned.
Using the stainless steel basket is highly recommended.
Never operate the unit without water in the cleaning tank. Always fill the
unit above 2/3 marker line indicated on the inside of the tank. Failing to do
so, may cause damage to the unit.
3)
Connect the power cable to the rear of the unit and ensure the wall supply
is switched ON. All the buttons are touch-sensitive, just lightly touch with your
finger. Touch the button on the front panel to turn on the machine.
You are now ready to set the timer and temperature.
4)
Setting the Temperature- When the power is on, the LCD will display the actual
temperature of the solution within the tank. The temperature setting figure will
flash once the option is pressed to set temperature. It indicates that the
temperature setting function has been started.
Then, press button to set the required temperature.
When the set temperature is higher than the actual temperature, the built-in
heater will initiate the heating function. The working status (OFF and ON) is visible
through the LCD display window. When the heater has reached the necessary
temperature, the heating function will stop automatically. When the
set temperature is lower than the actual one, heating will not start automatically.
In this case, the fluid will enter into the constant temperature state.
The heating function is not restricted by the ultrasonic cleaning timing but can
work for a long time (however, it is necessary to make sure there is enough
water inside the tank). To deactivate the heating function, input “00” in
preset temperature, then the Heater will be turned off.
Set:
Primes unit for adjusting
cleaning time. This is then
altered using + / – keys
above.
+/– Keys:
Use for adjusting settings.
Power On/Off:
Primes unit for adjusting
cleaning time. This is then
altered using + / – buttons
above.
Start/Stop:
Starts and stops ultrasonic
cleaner.
Degas:
Intermittent operation of
ultrasonic power for rapid
removal of entrained air
from liquids.
7
6
Summary of Contents for SONIC D
Page 1: ...SONIC D USER GUIDE...