James ULTRA 9020, User Manual

4. Turn the power switch on. Press Temp button to set the water temperature to 45ºC (113ºF). Press Heater 

button to turn on the heater,   flashes. Close the lid. LED 

 lights up. When water reaches the set 

temperature,   dims, indicating the heater is turned off. 

5. Press Time button to set the timer to 15 minutes. Press On/Off button to start cleaning. Grease will dissipate 

and appear to be like black smoke in the water.

6. When it stops, open the drainage valve to release the dirty water. Close the valve afterwards.

7. Clean the tank and add fresh water. Wash the items for another 3 minutes to remove the residual debris 

and the detergent.

Silver, copper or brass items with oxidation which has 

darkened the items will need special cleaning.

Suitable Locations: 

silver, copper or brass product 

manufacturers, home, shooting clubs.

Cleaning Method: 

Put the items in the basket and then in 

the tank, add water to a level between “MIN” and ”MAX” and 

above the area to be cleaned.
2. Add special solution (SeaClean2) that can remove silver 

or copper oxidation according to the ratio recommended 

(typically 1:10), Use special solutions according to the 

instructions for brass cartridges.
3. Turn the power switch on. Press Temp button to set the 

water temperature to 50ºC (122ºF). Press Heater button to turn 

on the heater,   flashes. Close the lid. LED 

 lights up 

indicating the percentage range of the set temperature being 

reached. When water reaches the set temperature,    dims, 

indicating the heater is turned off.

4. Press 

h/min button to set solution usage time. Each pressing increases the time by 20 minutes. Press 

button to reduce the time by 20 minutes each time. Common time is 

 or 

. Refer to the instruction from 

the solution manufacturer.
5. Press Time button to set the timer to 15 minutes.
6. Press Function button to select the degas function. 

button illuminates. Press On/Off to start degassing. 

After 90 seconds it changes over to normal cleaning automatically.
7. When it is done, remove the basket and the items. Rinse the items with tap water or follow steps 6 and 7 in 

the 

Enhanced Cleaning

 section.

Warm water and dishwashing liquid can soften grease and improve cleaning efficiency.

 SPECAL CLEANING

The heater has dual protection. It will be turned off automatically after 50 minutes.

During cleaning, debris will come off the items like “smoke”. Water will become murky. This method will 

remove silver or copper oxidation and debris in the decorating patterns and crevices and make the 

items like new again.

13